Olympus MX61 Montageanleitung - Seite 21

Blättern Sie online oder laden Sie pdf Montageanleitung für Mikroskop Olympus MX61 herunter. Olympus MX61 49 Seiten. 200mm/300mm compatible semiconductor/fpd inspection microscopes

Seite drucken

Fig. 22

Fig. 23

Fig. 24

Fig. 25

Setting Up the Power Supply Unit for Mercury Burner

CAUTION

!Cables and cords are vulnerable to bend or twist. Do not apply

excessive force to them.

!Make sure that the main switch is set to "

cords and cables.

!Always use the power cord provided by Olympus. If no power cord is

provided, please select the power cord by referring to the section "PROPER

SELECTION OF THE POWER SUPPLY CORD" at the end of this instruction

manual. If the proper power cord is not used, Olympus can no longer

warrant the electrical safety performance of the equipment.

1. Make sure that the voltage and frequency of the input power are within

the ranges indicated on the name plate @.

(100 V systems can be used with voltages in the 100 to 120 V range and

200 V systems can be used with voltage in the 220 to 240 V range, both

with frequencies of 50 to 60 Hz.)

2. Plug the connection cord to the connector ² on the power supply unit.

3. Attach the power cord to the power input connector ³ of the power

supply unit, and plug the power plug | of the power cord into the wall

power outlet ƒ.

!Always ensure that the grounding terminal is safety grounded/

earthed. If the equipment is not grounded/earthed, Olympus can no

longer warrant the electrical safety performance of the equipment.

Attaching the High-Intensity Light Source

Lamp Housing

1. Fit the MX-HGAD adapter @ all the way into the lamp housing mount

on the rear of the microscope arm, tighten the two clamping screws ²

using the Allen screwdriver.

2. Fit the mount section of the high-intensity lamp housing into the adapter,

confirm that the lamp housing is not tilted, and clamp the two clamping

screws ³ using the Allen screwdriver.

!When the high-intensity light source is used, the brightness becomes

too high during brightfield observation. Be sure to install the provided

ND filter (ND0.5*) in the brightfield observation light path.

* If the brightness after insertion of the ND0.5 filter is too low, use a different

ND filter (ND3 and ND6 filters available as options).

}The ND0.5 filter provided with the lamp housing can be mounted only by

the Olympus qualified personnel.

Connecting the Hand Switch (U-HSTR2)

!To prevent damage to the internal circuitry, always make sure that the

power cord is unplugged and the main switch is set to "

before connecting or disconnecting the hand switch.

Plug the hand switch connecting cable into the socket @ on the right

side of the microscope frame.

This operation should be performed after completing the

attachment of the lamp housing described in the next

section.

MX61/MX61L

" (OFF) before connecting

(Fig. 24)

(Fig. 25)

" (OFF)