Olympus CX-DO Anleitung Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Laborausrüstung Olympus CX-DO herunter. Olympus CX-DO 13 Seiten. Dual-viewing attachment

Seite drucken

Fig. 2

eyepiece

Fig. 3

Mount an observation

tube at the position

of both the main and

secondary observer.

1. Using the Allen screwdriver (TJ, loosen the observation tube clamping

screw on the dual-viewing

body.

2. Insert the circular dovetail mount at the bottom of the observation

tube @ into the opening on the dual-viewing

body, positioning the

observation

tube to point the binocular eyepieces

toward the front.

Clamp the observation

tube by tightening the clamping screw.

The eyepieces are mounted in the same manner as in the case of the

microscope itself. However, since the right eyepiece of both the main

and secondary observer

is used for pointer focusing, the eyepiece

mounted

in the right eyepiece

sleeve should either be a helicoid

eyepiece or one with diopter adjustment.

Q For details, refer to "Features"

at the beginning

of this instruction

manual.

Fig. 4

Fig. 5

1. Loosen the lamp socket clamping knob (iJ and remove the lamp socket.

(Fig. 4)

2. Screw the designated tungsten bulb (6VlOWGE) into the lamp socket.

(Fig. 5)

3. Insert the lamp socket into the socket holder and clamp by tightening

the clamping knob.

Do not touch the bulb with bare hands. Hold the bulb with

gloves

or a piece of gauze. If fingerprints

or smudges

are

accidentally

left on the bulb, wipe the bulb with a soft cloth.

+ Use only the designated

bulb type

for replacement,

i.e.,

GVIOWGE (mfd. by Hosobuchi

Denkyuu).

Precautions

for Bulb Replacement

The bulb and the lamp socket will be hot during use and right

after use.

Turn the main switch on the transformer

to OFF and disconnect

the power cord from the wall outlet. Then allow the old bulb

and lamp socket to cool before replacing

the bulb with a new

of the designated

type.