Olympus MX61A Handbuch - Seite 22

Blättern Sie online oder laden Sie pdf Handbuch für Laborausrüstung Olympus MX61A herunter. Olympus MX61A 48 Seiten. Motorized 300 mm compatible semiconductor/fpd inspection microscope

Seite drucken

Fig. 20

Fig. 21

Fig. 22

Setting Up the Power Supply Unit for Mercury Burner

CAUTION

This operation should be performed after completing the

attachment of the lamp housing described in the next

section.

Cables and cords are vulnerable to bend or twist. Do not apply

excessive force to them.

Make sure that the main switch is set to " " (OFF) before connect-

ing cords and cables.

Always use the power cord provided by Olympus. If no power cord

is provided, please select the power cord by referring to the sec-

tion "PROPER SELECTION OF THE POWER SUPPLY CORD" at the

end of this instruction manual. If the proper power cord is not used,

Olympus can no longer warrant the electrical safety performance

of the equipment.

1. Make sure that the voltage and frequency of the input power are within

the ranges indicated on the name plate @.

(100 V systems can be used with voltages in the 100 to 120 V range and

200 V systems can be used with voltage in the 220 to 240 V range, both

with frequencies of 50 to 60 Hz.)

2. Plug the connection cord to the connector ² on the power supply unit.

3. Attach the power cord to the power input connector ³ of the power

supply unit, and plug the power plug | of the power cord into the wall

power outlet ƒ.

Always ensure that the grounding terminal is safety grounded/

earthed. If the equipment is not grounded/earthed, Olympus can no

longer warrant the electrical safety performance of the equipment.

Attaching the High-Intensity Light Source

Lamp Housing

1. Fit the MX-HGAD adapter @ all the way into the lamp housing mount on

the rear of the microscope arm, tighten the two clamping screws ² us-

ing the Allen screwdriver.

2. Fit the mount section of the high-intensity lamp housing into the adapter,

confirm that the lamp housing is not tilted, and clamp the two clamping

screws ³ using the Allen screwdriver.

When the high-intensity light source is used, the brightness becomes

too high during brightfield observation. Be sure to install the pro-

vided ND filter (ND0.5*) in the brightfield observation light path.

* If the brightness after insertion of the ND0.5 filter is too low, use a different

ND filter (ND3 and ND6 filters available as options).

}The ND0.5 filter provided with the lamp housing can be mounted only by

the Olympus qualified personnel.

(Fig. 22)