Olympus SZ2-STU3 Anleitung Handbuch - Seite 8

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Laborausrüstung Olympus SZ2-STU3 herunter. Olympus SZ2-STU3 20 Seiten. Universal stand, table clamp stand

Seite drucken

OPERATION

Bonder arm rotation

clamping knob

Horizontal rotation/

vertical clamping knob

Horizontal movement

clamping knob

Drop prevention ring

clamping knob

Fig. 7

Fig. 8

Distal end

rotation screws

(x 2)

Fig. 9

1. To move the horizontal arm horizontally along the arm shaft, loosen the

horizontal movement clamping knob. Lift the microscope slightly for

smooth movement.

2. To rotate the horizontal arm by 360° around the column, loosen the hori-

zontal rotation clamping knob.

When rotating the horizontal arm, confirm that that the drop prevention

ring clamping knob is tightened firmly and in close contact with the

horizontal arm section.

3. To move the horizontal arm upward, keep the drop prevention ring clamp-

ing knob tightened but loosen the vertical clamping knob. After lifting the

horizontal arm to the desired position, tighten the vertical clamping knob

again. And then move up the drop prevention ring till immediately be-

neath the horizontal arm section and clamp the ring again.

To move the horizontal arm downward, always move down and clamp

the drop prevention ring before moving the horizontal arm downward.

Never loosen two clamping knobs simultaneously, as this is extremely

dangerous.

4. To rotate the bonder arm horizontally, loosen the bonder arm rotation

clamping knob. (Fig. 8)

5. To rotate the distal end of the horizontal arm with respect to the arm,

loosen the two screws at the distal end using the provided Allen wrench.

(Fig. 9)