Olympus U-DO3 Anleitung Handbuch - Seite 13

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Laborausrüstung Olympus U-DO3 herunter. Olympus U-DO3 18 Seiten. For 2, 5, 9, 10 and 13 persons
Auch für Olympus U-DO3: Anleitung Handbuch (40 seiten)

Seite drucken

QAssemble the discussion attachment by referring to the layout shown in Chapter 1 on page 3.

* Install the discussion attachment and the modules combined with it on a same Single desktop surface. With the U-

MDOlO-3 multi-viewing attachment, prepare a big desk surface (1250-1400 mm (W) x 1100-1250 mm (DJ).

Fig. 6

1. Remove the Observation tube from the microscope frame 0 in use, and

attach the discussion attachment 0 equipped with the pointer control

lever

2. When the U-MDOlO-3 multi-viewing attachment is used, attach another

module (IJ-MDOlOB3).

3.Attach the Observation tune removed before above the discussion at-

tachment.

Fig. 7

Fig. 8

Screw in the top of the stand 0 into the mount hole 0 on the bottom side

of the side-view tube 0.

1. Remove the taps from the mounts on the side-view tube and micro-

scope frame.

2. Loosen the stand moving/locking

knob 0 and, while lifting up the stand,

fit the side-view tube into the side-view tube mount 0 on the microscope

frame.

3. When the side-view tube is parallel with the desktop surface, tighten the

stand moving/locking

knob.

4. Turn the mount ring 0 of the side-view tube to clamp it against the micro-

scope frame

@After assembly, be Sure to adjust the height of the side-view tube

stand.

If the side-view tube and desktop surface are not parallel, the periphery

areas of the assistant observers' fields of view may be tut off or deviation

may be observed between the fields of view of the main and assistant

observers.

To adjust the height, leck the stand moving/locking

knob so that the

side-view tube and the desktop surface are almost in parallel, then check

if the periphery areas of the assistant observers' fields of view are tut off

and if there is deviation between the fields of view of the main and assis-

tant observers. If either is detected, loosen the stand moving/locking knob

slightly, fine adjust the height of the stand and tighten the stand moving/

locking knob firmly.