Axminster CSC500C Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Werkzeuge Axminster CSC500C herunter. Axminster CSC500C 8 Seiten. Woodturning chuck set

Good Working Practices/Safety

The following suggestions will enable you to observe good working

practices, keep yourself and fellow workers safe and maintain your

tools and equipment in good working order.

WARNING!!

1. Do not wear gloves or loose clothing when turning.

2. Do not wrap any strip sandpaper or clothing around your hands or fingers when

sanding or turning.

3. Use proper eye protection when turning.

4. Check your wood for splits, weakness or cracking prior to mounting on the

chuck.

5. Confirm that the wood is tightly gripped before turning your chuck under power.

6. Rotate the chuck manually prior to starting your lathe to confirm proper

clearance.

7. Always check and re-lighten after any problem or catch.

8. Use appropriate speeds as referenced in instructions.

9. Always turn with sharp lathe chisels.

10. Capture fine particles from the air with a dust collector.

11. Keep clean and lubricate with at light oil as needed.

Model Number:

A CSC500C Chuck set (pre threaded for 1" x 8tpi)

B 1. Set (4 piece) of #2 round jaws (shipped pre-mounted to chuck)

C 1. Hex wrench

D 2. Tightening levers

E 1. Set (4 piece) step jaws

F 1. Set (4 piece) extended pin jaws

G 1. Screw chuck

H 1. 3/4" x 16tpi adapter

Instruction Manual

Safety Instructions for Chuck Systems...

FREEPHONE

KEEP TOOLS AND EQUIPMENT OUT

OF THE REACH OF YOUNG CHILDREN

0800 371822

CSC500C