Axminster AW12BM Benutzerhandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Bohrer Axminster AW12BM herunter. Axminster AW12BM 20 Seiten. 12mm bench morticer

Seite drucken

1. What's in the Box

Parts Identification and Description (Continued)

Hold Down Yoke This is a small 'U' shaped yoke casting. The underside of the arms of the 'U'

(See fig 4b)

Chisel mounting The chisel mounting flange is a raised annular housing machined at the

flange

(See fig 1c)

Chuck access

door

(See fig 1)

Accessory

mounting panel

(See fig 4a)

Chuck guard

(See fig 5a)

1-13mm/B6

drill chuck`

(See fig 5d)

B6 to parallel

shank shaft

(See fig 5d,5e)

Fig 4a

Accessory mounting panel

are flat, to rest on the workpiece. In the middle of the yoke is a land

sufficiently large enough to be bored through to accept the mounting rod.

There is a grubscrew threaded through the wall of the hole so that the hold

down can be secured in position.

bottom of the headbox. It has a 3/4" adaptor pressed into it, which is used to

clamp the chisels in position. It is also used to mount the guard when the

morticer is used in 'Drill' mode.

Access to the chuck for loosening or tightening is via a rectangular hole in

the front of the headbox casting. This hole is covered by a hinged door. The

door is held closed by a sprung catch moulded into the door.

A plastic block, with various holes moulded into it to allow the chisel sets,

chuck key, allen keys etc, of the machine tool kit, to be stowed safely out of

the way but close to hand.

A hinged and telescopic guard that is fitted to the headbox lower bearing

flange during drilling operations. (Remove the bolt for the chisel clamping) It

has a spring fitted to the hinge geometry to hold the guard "over

centre" to maintain it in the raised or lowered position. The guard shield can

be extended or retracted (telescoped) as required, using the second leaf, the

second leaf is held in position by two butterfly nuts and bolts.

A standard 12mm chuck with an internal B6 taper mount. Used in conjuction

with the mounting shaft to transpose the mortiser into a small drill press.

The mounting shaft for the drill chuck, the main shaft has a diameter slightly

smaller than the adaptor for the chisels.

Fig 4

Fig 4b

Hold down yoke