AccuMate TM76 Gebrauchsanweisung Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung Handbuch für Stromversorgung AccuMate TM76 herunter. AccuMate TM76 12 Seiten.

Instructions for Use

: IMPORTANT :

www.accumate.com

Read before using.

WARNING !

Batteries emit EXPLOSIVE GASES - prevent flame or sparks near batteries . Disconnect AC

power supply before making or breaking DC/battery connections. Battery acid is highly corrosive.

Wear protective clothing and avoid contact. In case of accidental contact wash immediately with soap and

water. Check that the battery posts are not loose; if so, have the battery professionally assessed.

If the battery posts are corroded, clean with a copper wire brush; if greasy or dirty, clean with a rag damped

in detergent. Before charging batteries provided with filler caps check that the electrolyte level is correct, and

top up with distilled water if necessary. Do not use the charger unless all output leads and connectors are in

good, undamaged condition.

Protect the device, it's leads, connectors, fuse holders, fuses and terminations from contamination by

acids and fluids, from exposure to damp and humidity, and from physical and accidental damage.

Any damage to the unit, it's leads or accessory parts resulting from such contamination, exposure or

damage is NOT covered by warranty.

NOTE : This device is delivered with 2 detachable connection lead sets. These sets terminate at one end with

the male element of a special 2-pin connector to insert in the female element which terminates the main char-

ger output cable. At the other end, one connection set has «crocodile» clips for quick connection to the bat-

tery, and a second set has metal eyelets for permanent fixing to the battery posts.

If intending to charge a 12V lead-acid battery using the battery clips, first disconnect and remove the battery

from the vehicle and place in a well ventilated area. To connect the eyelet connection set, fix the eyelets

firmly through the holes in the battery posts with galvanised gutter bolts and nuts or in the case of solid posts

by galvanised self- tapping screws engaging in suitable holes pre-drilled in the posts. Make sure that the

eyelet with red heatshrink is fixed to the positive pole (marked Pos or P or + and often red) and the other eye-

let to the negative pole (Neg or N or - and often black). Ensure that the polarised connector is situated away

from the battery and restrained so as not to come into contact with any moving part of the vehicle. Prevent

ingress of grime and dirt to the 2-pin connector. If any optional accessory connection lead incorporates a fuse

and thus should blow, check for damage or anomalies and replace any burnt fuse only with a new fuse of

identical type and rating.

If in any doubt concerning any of the above instructions, consult a professional service agent for assistance.

LED (light emitting diode) indicator information panel

Float mode

2 main

Power ON

tops up & maintains charge

charging stages