Axminster Trade 101701 Original-Bedienungsanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Original-Bedienungsanleitung für Sander Axminster Trade 101701 herunter. Axminster Trade 101701 18 Seiten.

Seite drucken

Assembly

Stand Assembly

Referring to Figure 1:

1. Remove

all

contents from

container.

2. Clean all rust protected surfaces with a mild

solvent. Do not use paint or lacquer thinner,

gasoline, or mineral spirits; these will damage

painted surfaces.

3. Attach the four rubber pads (A) to the bottoms

of the side panels (C) with four each

hex nuts (B). The hardware can be found

in the bag with the rubber pads.

4. Attach the side panels (C) to the front panel (D)

with four 5/16" x 5/8" hex cap screws, eight

5/16" flat washers, four 5/16" lock washers, and

four 5/16" hex nuts (E).

hardware at this point.

Note: Assemble the stand upside down to

make sure that the tops of the panels are flush.

5. Mount the shelf (F) to the inside of the stand

with two M5x10 pan head screws, two M5 flat

washers and two M5 lock washers (G).

6. Finish the stand assembly by attaching the rear

panel (H) to side panels (C) with four

5/16" x 5/8" hex cap screws, eight 5/16" flat

washers, four 5/16" lock washers, and four

5/16" hex nuts (J).

7. Make sure stand is sitting evenly on a level

surface before tightening hardware.

Installing Table and Motor Unit to Stand

The Table and Motor Unit is

heavy! Use great care and adequate resources

when lifting the unit up onto the stand! Failure

to comply may cause serious injury and/or

damage to the sander and/or property!

Referring to Figure 2:

1. With the aid of another person, carefully lift the

table and motor unit (A) out of the shipping

box, and up onto the stand (B).

2. Line up threaded holes in the base (C) with the

holes in the stand (D).

3. Open the cabinet door (E) and through the

opening attach main unit to stand with two

5/16" x 1-1/4" hex cap screws (F), two 5/16"

lock

washers

(G)

washers (H). Tighten with a 12mm wrench.

the

shipping

Hand tighten the

and

two

5/16"

flat

Figure 2