AccuMed AP212 Benutzerhandbuch - Seite 10
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Pulse Generator AccuMed AP212 herunter. AccuMed AP212 15 Seiten. Mini electronic pulse stimulator
Seite druckenTROUBLESHOOTING:
If your device is not operating properly, please check below for common problems and suggested solutions:
1.
No power source; no display in LCD:
•
Check if the battery is low and needs to be recharged.
•
If the unit was previously used, switch the power to OFF first, then back to ON.
2.
Stimulation is weak or nonexistent:
•
Check that the electrode pads are firmly attached to skin.
•
Check that the electrode pads are not touching each other.
•
Check that electrode pad are not stacked together or overlap.
•
Check that the cord is properly connected to the unit.
•
Check if the battery is low and needs to be recharged.
•
The intensity level is very low.
•
Both pads from the same wire must be attached to one person's body to feel sensation.
3.
Electrode pads are not sticky:
•
The electrode pads lost their adhesiveness and need to be replaced.
•
Wash adhesive surface of pads softly with your fingertips for about 3 seconds under slow running water.
•
Make sure you are not perspiring and are in a cool room when using.
•
If electrode pads were applied immediately after washing, make sure to dry the pad before applying.
•
If the electrode pads were exposed to high temperature, high humidity, or direct sunlight, the electrode pads may have
been ruined.
4.
The skin turns red or the skin feels irritated:
•
The therapy time is too long or the intensity is set too high.
•
The adhesive surface of pads is dirty or dry and must be washed.
•
If problem persists, stop using device and contact your physician.
5.
One pad feels stronger than the other:
•
This is normal. Different areas of your body will react differently.
•
Make sure the pads are sticky and are making good contact.
6.
Power cut off during use:
•
Check if battery is low and charge if necessary.
•
Check that cord is intact and is not broken.
10