Accura MINT Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Fan Accura MINT herunter. Accura MINT 5 Seiten. Portable heat recovery ventilator

Seite drucken

RECOMMENDATIONS



The product can be installed in a space with a floor area of up to 200 ft



Screens (not bundled with the product) can be attached to the ports of the ventilation kit to

prevent the encroachment of animals that can damage the product or constitute hazard to

the building occupants.



The ducts (B and D) should be installed without any bends that may impede the flow of air.



The ducts (B and D) may be insulated to minimize energy losses to the building space.

Maintenance

Although the product is designed to operate with minimal maintenance, a few activities

NOTE 

may be performed during the course of using the product.

The heat exchanger (H)

shall not be washed.

The product shall be shut down before any maintenance activity is performed.

Filter

It is recommended to change the filter in the supply vent (A) at least once a year

NOTE 

depending on the outdoor air quality. The procedure for changing the filter is

A filter shall not be

presented as follows:

installed in the exhaust

vent (C).



To remove the old filter in the supply vent (A):

o Shut down the product;

o Open the door of the enclosure;

o Locate and hold the heat exchanger (H) firmly with one hand;

o Carefully twist and pull out the supply vent (A) with the other

hand.



Remove the filters in the supply-vent (A) port and replace them with two

sheets of an air filter pad that are cut to 5" × 7" (~12.7 cm × ~17.8 cm). A

filter with a minimum efficiency reporting value of 4 is recommended.

Window/Door/Wall

Product

Duct Vent kit

Figure 3. Installation of the product using a vent kit.



To reinsert the supply vent (A):

o Remove the tape that is wrapped round the base perimeter of the

NOTE 

supply vent (A) and clean the vent with a paper towel that is

Excessive force shall not

moistened with isopropyl alcohol.

be applied when

o Attach a roll of 24-mm green paper tape (also known as a painter's

replacing the filter in the

supply vent (A).

tape) to cover three-quarters of the base perimeter of the

supply vent (A).

o Use one hand to hold the heat exchanger (H) and ensure that it

lines up with the port of the supply vent (A) at the top of the

enclosure;

o Use the other hand to insert the supply vent (A) into the port until

it is flush with the top surface of the enclosure.

Duct

A damaged duct can be replaced by using a similar duct with a diameter of 4"

NOTE 

(~10.2 cm). The following steps can be followed when changing a duct:

The length of a newly

installed duct shall be



5" (~12.7 cm).

Shut down the product;



Loosen the nuts of the clamp of the damaged duct using an 8-mm

NOTE 

nut driver;

Do not apply excessive

force when tightening

the clamp.



Remove the damaged duct from the port of the appropriate fan;



Attach a new duct to the port of the appropriate fan;



Tighten the nuts of the clamp.

Electrical Parts

An electrical part (F, G, I and J) shall only be replaced if it is faulty. In this situation, the

product shall be shut down and the manufacturer shall be consulted for further

instructions.

†

Caveat

The Caveat applies to products that are not purchased directly from the manufacturer.

The electrical parts (F, G, I and J) of the product are deemed to be certified to ensure

customer safety. Products are submitted for field inspection only if they are purchased

directly from the manufacturer. Consequently, the manufacturer is not liable if

additional approval is required by the Authority Having Jurisdiction where the product

is purchased and/or installed.