Arc-Zone DGP-2-V2 Betriebshandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Schleifer Arc-Zone DGP-2-V2 herunter. Arc-Zone DGP-2-V2 13 Seiten.

Seite drucken
t

7 . GRINDER MAINTENANCE

Grinder should Be Maintained properly
• Always unplug grinder before inspection.
• Keep the grinder clean for safest operation
• Remove adjusting keys and wrenches. Form a habit of checking that keys and adjusting wrenches are removed
before the grinder is turned on.
• Keep all safety guards in place and in good working order.
• Keep all parts in working order. Check to determine that the guard or other parts will operate properly and
perform their intended functions.
• Check for damaged parts and alignment of moving parts, binding of moving parts, breakage of mounting parts
and any other condition that may affect the grinders operation. Consult DGP factory for replacement parts
at: (805) 498-3837.
Work area should Be ready for the Job
• Keep work area clean.
• Do not use power tools in dangerous environments, such as damp or wet locations. Do not expose power tools
to rain.
• Work area should be properly lighted.
• The proper electrical outlet should be available for the tool. For 110V, a three prong plug should be plugged
directly into a three prong outlet and /or extension cord.
• Keep visitors a safe distance from work area and keep children out of work place. Use padlocks, master
switches, and remove starter keys to prevent any unintentional use of power tools.
t

8 . TROUBLESHOOTING CHART

sYMptOMs
Grinder won't start
Excessive vibration
Grooved wheel
Motor is overheating
Document: DGP-2 & DGP-2-V2 Tungsten Grinder Product User Manual | Released: 5/13, Rev. A
Copyright©2017, Arc-Zone.com®, Inc. All Rights Reserved
6 / 13
troubleshooting chart
pOssIBlE caUsEs(s)
1. Blown line or tripped circuit
breaker
2. Low line voltage
3. Material wedged between
wheel and guard
1. Improper mounting of grinder
or accessories
2. Improper wheel mounting
1. Electrode pushed with
excessive force
2. On steep angled tungesten,
collet touching wheel
1. Motor not turning freely
(without power)
cOrrEctIVE actIOn
1. If fuse is blown, replace with fuse of proper
size. If breaker is trpped, reset it.
2. If voltage is less than rated, check size of
wiring from main switch on property. If OK,
contact power company.
3. Remove material wedged between wheel and
guard
1. Remount
2. Remount wheels but rotate one wheel 1/4 turn
with respect to its previous position. Other wheel
would retain its original position.
1. Use recommended grinding times table
2. Use short collets available from Diamond
Ground Products
1. Clean around wheels & shaft.
Then replace bearings
Arc-Zone.com, Inc.
2091 Las Palmas Drive, Ste. F
Page 6
Carlsbad, CA 92011 - Tel. 1.760.931.1500