Accurate Technology DigiStop-4 Handbuch für Installation und Betrieb - Seite 11

Blättern Sie online oder laden Sie pdf Handbuch für Installation und Betrieb für Messgeräte Accurate Technology DigiStop-4 herunter. Accurate Technology DigiStop-4 20 Seiten. Digi-stop series

Seite drucken

additional 1/64 of an inch measurement making the true, full resolution

measurement 2 13/64ths.

Some users find this resolution unnecessary and prefer the 16ths or 32nds

mode instead. For better resolution, switch to 64ths mode. For the best

resolution switch to a decimal mode – inches or millimeters..

When the measurement is greater than 99 63/64 inches, a +100 and/or +200

will illuminate in the upper right portion of the display to indicate this amount

must be added to the displayed reading. For example; the LCD pictured above

right is indicating a measurement of 151 39/64 inches. If the measurement was

351 39/64 inches, the +100 and +200 will be illuminated on the display.

, and -

DATUM

The

(plus),

DATUM

displayed position to a different value. The

user programmed value.

Momentarily depressing the

(fractions, decimal or mm depending on the current mode selected by the

key) of measurement. Momentarily depressing the

UNITS

the current reading by one unit. Pressing and holding the

the displayed reading to change continuously. Holding down the key will cause

the amount of change to speed up. This allows for quick adjustments over a

range of large values.

NOTE: While the

displayed reading, it can also be programmed to force the readout to a preset

value. This can be zero, or any other displayable value.

See Section 3: Readout Programming,

Reverse the Measurement Readings

Reverse the readings means changing the direction of measurement produced

by movement. If the Digi-Fence decrements (reduces or goes negative) when it

should be incrementing (increasing or going positive), the readout will need to

be re-programmed for your installation.

See Section 3: Readout Programming,

Accurate Technology Digi-Stop

–

and

(minus) keys are used to change the currently

Programming Parameter Pr1

key increments the current reading by one unit

key can be used to simply "zero" the currently

DATUM

key forces the readout to a

DATUM

Programming Parameter Pr1.

Programming Parameter Pr2.

(default is zero 0.00)

–

key decrements

–

keys will cause

Page 11 of 20