Arcam Delta 60 Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Handbuch für Verstärken Arcam Delta 60 herunter. Arcam Delta 60 12 Seiten. Arcam integrated amplifier handbook
Auch für Arcam Delta 60: Handbuch (12 seiten), Service-Handbuch (13 seiten)

Seite drucken

Delta 60 integrated amplifier handbook

Mono

The amplifier is in its normal stereo mode when the mono

button is out. In this position, the left and right input signals are amplified

independently to feed the corresponding loudspeaker outputs. When the

mono button is pushed in the left and right signals are mixed together and

the combined signal is routed to both loudspeakers. This is particularly

useful when listening to mono records or tapes (as much low frequency

out-of-phase rumble can be eliminated) or to remove excessive hiss from

FM broadcasts. It is also invaluable for checking speaker phasing in a stereo

hi fi system.

Tape 2 recording/monitoring

All sources, disc, CD, tuner and Tape I can be recorded via the

Tape 2 connections. To record an input select the required source and set

your recorder into the record mode. If your tape machine is a three head

type suitable for A/B monitoring then pressing the Tape 2 switch will allow

off tape monitoring.

Playback

Press the Tape 2 switch and set your recorder into the

playback mode.

Phones

The headphone socket will accept any headphones fitted with

a standard quarter inch (6.35mm) stereo jack plug. The headphones may

be operated in parallel with the loudspeaker outlets, or not, as you wish

(see Loudspeakers above).

Tape recording

The Delta 60 has facilities for two tape recorders. The Tape

I input is most suitable for use with two head tape recorders and video

recorders. The Tape 2 input, in addition to the above, is ideally suited

for use with three head tape machines, where tape monitoring

is a requirement.

Tape 1 recording

To record an input simply select the required source - either

Disc, CD or Tuner - and set your recorder into its recording mode. Note,

it is not possible to record signals from the Tape 2 source to Tape 1.

Playback

Depress the Tape 1 switch and set your recorder into the

playback mode.