Arcam FMJ A28 - V1 Handbuch - Seite 11

Blättern Sie online oder laden Sie pdf Handbuch für Verstärken Arcam FMJ A28 - V1 herunter. Arcam FMJ A28 - V1 17 Seiten.

Seite drucken

A28 setup

Configuring your A28 amplifier

adjusting listening settings

The A28 allows you to customise various features of the

amplifier to fit your system. Use this diagram to help you

navigate through the available configuration options.

In the diagram, the control knob is shown as

Normally, the display shows the source and the current

volume.

Press

once to enter the setup menu, use the

control knob to cycle through the menu items. When

Balance

This allows you to adjust the output balance between left and right channels. The balance

control is also available directly by pressing the front panel

Vol Res

There are three volume-display options to chose from: 'Std' , 'Fine' or 'Ref' . Standard and

Fine represent different levels of volume-control sensitivity; the Reference setting gives

absolute increments in 0.5dB steps.

I/P Trims

Input trims are used to compensate for variations in output levels of different source

equipment. If, for example, your CD player is louder at a given volume display value

than other inputs, you can attenuate it by using this setting so that it matches your other

components.

Use the source-select buttons to select the input you wish to adjust, then the control knob

to set (increase or decrease) the input volume for that source.

Proc Mode

Processor mode enables you to fix the gain (volume setting) of your A28. The A28 (in

combination with a power amp.) can then be used to drive the front left and right speakers

of a surround-sound system, when fed from a separate processor. The volume of the entire

system can then be controlled using the processor.

Feed the sound from the processor into the

the amplifiers that drive your other loudspeakers.

To record one source while listening to another, turn the control knob until the display

REC SRC

shows 'Rec ' followed by the name of the input (Sat, Phono, CD, Tuner, AUX or DVD)

that you wish to record from. The record source control is also available directly by

pressing the front panel

RECoRD

This can be used to limit the maximum volume the amplifier operates at when it is first

Max onvol

switched on: the A28 comes on at the (reduced) 'Max. On Volume' level if the last-used

volume exceeds this value.

If this item is set to 'Off' , the A28 always comes on at the last used volume, even if this is

very loud.

Reset

Confirming 'Yes' restores all amplifier settings to their factory defaults.

you have found the setting that you wish to adjust (as

shown on the front panel display), press

. To adjust

the chosen setting, use the control knob. Press

store the change and return to volume display mode – or

press

again to move to the next setting.

Note that the menu will time-out after a short period

without pressing a button or adjusting the control knob,

with the display reverting to the current volume.

The following items can be adjusted from the setup

menu:

button.

BALANCE

input, then set the gain of the A28 to match

button.

e-11

'Power On' state

VOLUMEOOO

BALANCEOO

L ,

;

VOL

RESOO

RES REF

RES FINE

RES STD

I/PoTRIMS

AUX TRM -8 . . . 8

PROC MODE

PROC AV

FIXED 3 . . . 72

REC SRC

REC SAT��PHONO��CD�

TUNER��AUX��DVD

MAX ONVOL

ONVOL OFF

ONVOL 3 . . . 72

RESET0000

, R

YES