Arcam FMJ A32 Handbuch - Seite 8

Blättern Sie online oder laden Sie pdf Handbuch für Verstärken Arcam FMJ A32 herunter. Arcam FMJ A32 16 Seiten. Amplifiers
Auch für Arcam FMJ A32: Service-Handbuch (18 seiten)

Seite drucken

RECORDING

With the Arcam A32 it is possible to listen to and record from one

source, or to listen to one source while recording another.

Both sets of tape sockets are identical in sensitivity and suitable for use

with almost any type of recorder (cassette, CDR, MD, VCR, reel-to-

reel, etc.). The record signal is sent to both the

sockets.

RECORD

To record the currently selected source, press

shows 'RECORD SOURCE'. After a few seconds the display reverts to

showing the volume level and you are ready to record.

To listen to one source while recording another, press

until the display shows 'RECORD' followed by the name of an input (e.g.

'AUX', 'CD', 'TUNER', etc.). Now press the source selector button on the

front panel for the source you wish to record. Your selection is shown

on the display for a few seconds, after which it reverts to showing the

volume level and you are ready to record.

The

button can also be used as a second zone selector,

RECORD

sending a source signal at line level to a second amplifier operating in

another room. If you need help with this, contact your Arcam dealer

or Arcam customer support.

Tape-to-tape copying (dubbing)

You can perform tape dubbing from

VCR

For example, to copy from a cassette recorder connected to the

socket to a cassette recorder connected to the

button as explained above and select 'RECORD VCR'. This

the

RECORD

routes the VCR signal to the

TAPE

Set the cassette recorder connected to the

mode and the other to playback mode to start dubbing.

TAPE

To play back the recording from a cassette deck attached to the

input, press

. '

' is shown on the display. Selecting this input

TAPE

TAPE 1

overrides the other source selectors.

It is also possible to monitor a recording while it is being made,

provided your cassette deck is a 3-head type. To do this, press

Switching this button in/out allows an A/B comparison between the

source signal and the recorded signal.

and

output

TAPE

VCR

until the display

RECORD

, but not from

VCR

TAPE

socket, first use

TAPE 1

output.

socket into its record

TAPE

again

VCR

TAPE 1

TAPE