Arcam P90 Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Handbuch für Verstärken Arcam P90 herunter. Arcam P90 15 Seiten.

Seite drucken

Using the remote control

CR-389 Remote Control

The CR-389 remote control gives access to all functions

available on the front panel of the A90. It also has controls to

operate Arcam CD players, AM/FM tuners and DAB tuners.

The remote control transmits Philips RC-5 type codes.

These buttons are used to control tuner functions.

Note that the FM/DAB lights indicate into which mode

you are switching the remote control. The lights only

illuminate for five seconds to conserve battery power.

If neither light is illuminated this does not mean that the

remote control is not working!

Perform the same function as the

on the front panel (see page 6).

Performs the same function as the

button on the front panel (see page 8).

Performs same function as the

panel. It allows you to use the remote's volume switch in the

same way you use the control dial on the front panel – to

adjust various amplifier settings (see page 8).

Note that pressing + corresponds to turning the

Control knob clockwise, – to anticlockwise.

Source selection buttons

These operate in the same way as the source selectors

on the front panel of your integrated amplifier.

NOTE: Remember to install the two supplied AAA batteries

before trying to use your remote control!

Do not place anything in front of the IR receiver on the left

of the A90, or the remote control may not work.

TUNER

(UP and DOWN)

buttons

ENTER

SELECT

button on the front

SELECT

TUNER

DAB

Power/Standby

Toggles the amplifier between standby mode and full power

mode. The power indicator light next to the power button on

DISP

DAB

the front panel is red if the amplifier is in standby, amber while

the amplifier is powering up (this only takes a few seconds) and

1-9

2-10

3-11

4-12

green when the amplifier is powered up.

5-13

6-14

7-15

8-16

SP1 and SP2

MODE

BAND

These buttons allow you to select and deselect the main (SP1)

and secondary (SP2) sets of speakers attached to your amplifier

SP1

(see page 6).

ENTER

SP2

DISP

DISP (display)

SELECT

Cycles through the settings 'Bright', 'Off' and 'Dim'. Turning the

display 'Off' generally gives a slight improvement in sound quality.

Volume and

Press

of the amplifier.

PHONO

AUX

TUNER

Press

Both tape outputs and the headphone socket remain active.

TAPE

VCR

DVD

Mute is disabled either by pressing

volume.

AMPLIFIER

You can use the remote's volume control in conjunction with the

RPT

SELECT

PROG

INFO

CD controls

These offer basic controls of Arcam CD players

CR-389

(mute)

to increase volume or

to decrease the output volume

–

to mute the speaker connections and preamp outputs.

again, or by adjusting the

button to adjust balance, tone and amplifier settings.

A90/P90