CIPU CSPPD705 Handbuch - Seite 6
Blättern Sie online oder laden Sie pdf Handbuch für Schwimmbadpumpe CIPU CSPPD705 herunter. CIPU CSPPD705 13 Seiten.
Seite drucken
ENSURE that all suction and discharge valves are open before you start the pump, otherwise
that all suction and discharge valves are open before you start the pump, otherwise
that all suction and discharge valves are open before you start the pump, otherwise
will result in damage to the pump.
Two-Speed Pumps
Two-speed models are recommended in a swimming pool when high speed is needed for
speed models are recommended in a swimming pool when high speed is needed for
speed models are recommended in a swimming pool when high speed is needed for
maximum filtration at peak periods and whenever turbidity levels are high. At other times,
maximum filtration at peak periods and whenever turbidity levels are high. At other times,
maximum filtration at peak periods and whenever turbidity levels are high. At other times,
switch to low speed. For backwashing and vacuu
switch to low speed. For backwashing and vacuuming, high speed is required. In spas and hot
tubs, use high speed to attain full performance in the hydro-therapy mode. At other times, such
tubs, use high speed to attain full performance in the hydro
as filter/heat cycle mode, use low speed. Low speed provides sufficient flow to activate most
as filter/heat cycle mode, use low speed. Low speed provides sufficient flow to activate most
as filter/heat cycle mode, use low speed. Low speed provides sufficient flow to activate most
spa heaters and provides sufficient flow for filtration.
performance in the hydro-therapy mode and use low speed mode to prime. The below
shows the positions of high speed and low speed.
the positions of high speed and low speed.
Maintenance
The strainer basket in the filter tank should be inspected and cleaned at
The strainer basket in the filter tank should be inspected and cleaned at regular intervals.
1. Remove lid and lift out basket.
2. Remove debris and hose off with clean water if necessary.
2. Remove debris and hose off with clean water if necessary.
3. Inspect the lid gasket, lubricate with silicon based grease
3. Inspect the lid gasket, lubricate with
only if needed. If it is damaged, pls replace.
only if needed. If it is damaged, pls replace.
4. Replace the strainer.
5. Re-prime the filter tank.
6. Correctly locate the o-ring.
7. Replace the lid hand tighten only.
8. Switch on pump.
ufficient flow for filtration. In jetted tubs, use high speed to attain full
therapy mode and use low speed mode to prime. The below figure
therapy mode and use low speed mode to prime. The below
only.
5
ming, high speed is required. In spas and hot
therapy mode. At other times, such
In jetted tubs, use high speed to attain full
regular intervals.