Circadiance SleepWeaver Elan Gebrauchsanweisung - Seite 2
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Medizinische Ausrüstung Circadiance SleepWeaver Elan herunter. Circadiance SleepWeaver Elan 2 Seiten. Nasal mask
Seite druckenFitting the Mask Continued
1. Put the mask on by pulling the headgear over your head.
2. The neck support of the headgear should sit comfortably on the lower part of
your neck.
IMPORTANT – DO NOT OVERTIGHTEN THE STRAPS. START WITH THE
STRAPS LOOSE AND THEN TIGHTEN AS NECESSARY TO ACHIEVE AN AIR-TIGHT SEAL.
3. Adjust the bottom (blue hook tab) straps to pull the mask comfortably against
your nose. A small amount of the black fabric will show when the mask is in use.
4. Adjust the top (white hook tab) straps so that the bottom of the mask is
comfortably resting on your upper lip just below your nostrils.
5. Attach the Feather Weight Tube
tube that attaches to your CPAP or Bi-Level machine and turn on machine.
6. Lie down in your normal sleeping position and if needed shift the mask around
so that the fabric is able to form a seal against your skin. Additional adjustment
tips are located in the following section and a detailed fitting video can be viewed
at www.circadiance.com/help.
Adjusting for Leaks - If you experience leaks, try these steps:
1. Gently tighten the straps in very small increments to achieve a seal.
2. Wiggle the mask into place by shifting the mask left and right and up and down.
The adjustment tab on the bottom of the mask can be used to assist during this
process.
1A.
1B.
Cleaning the Mask in the home
• Your SleepWeaver Élan should be cleaned by hand washing with a mild
nonabrasive soap in warm water every other day. Never use hot water.
Repeat washing until visibly clean.
• Rinse well with drinking quality water and allow to air dry out of direct sunlight.
• You may keep the 90 degree elbow swivel attached during cleaning or you may
remove it and clean it separately.
• Hand wash the headgear weekly.
Cleaning & Disinfecting Between Patients
• Please visit www.circadiance.com/help for instructions.
to the 90 degree elbow swivel then to the 6 foot
®
2.
Attach Mask to Headgear
1. Slide the "White" hook tabs through the top slits of the cushion.
2. Slide the "Blue" hook tabs through the bottom slits of the cushion.
Attach 90 Degree Elbow
Swivel to Mask Cushion
1. Slide the "Thread" piece through
the opening from inside the mask.
2. Place the "Washer" piece over the
"Thread" piece.
3. Ensure that the fabric does not ride
up onto the thread piece.
4. Screw the "Nut" piece onto the
"Thread" piece.
Attach Tether Strap to Headgear
1. Attach the "Tether Strap" to the Feather Weight
Tube and to the top of the headgear to assist
with tube management if the tube is directed
over your head.
2. Ensure that the "Tether Strap" is not twisted
when attached.
Warnings
• The device is a vented mask and should not be used with a dual limb ventilation
circuit.
• If there are any reactions to any part of this mask or headgear, discontinue use
immediately.
• This system should not be used unless the therapy device is turned on and is
operating properly.
• The vent holes should never be blocked.
• Ensure the mask is put on correctly. Ensure the mask and headgear are
assembled and positioned as shown on the front page of these Instructions.
• If any visible deterioration of a system component is apparent (cracking,
broken parts, tears, etc.), or if after cleaning any components remain unclean,
the component should be discarded and replaced.
• Varying the frequency, method, or cleaning agent to clean this product other
than what is detailed in these instructions may have an adverse effect on
SleepWeaver Élan and consequently the safety or quality of the therapy.
• If the mask is being used with supplemental oxygen, the patient should refrain
from smoking
• If the mask is being used with supplemental oxygen, the oxygen flow must be
turned off if the machine is not operating because accumulated oxygen is a fire
hazard.
"Thread"
"Washer"
"Mask Cushion "
"Nut"
"Elbow Swivel"
"Tether Strap"