Axxera AXA10D Installations- und Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Installations- und Benutzerhandbuch für Verstärken Axxera AXA10D herunter. Axxera AXA10D 13 Seiten. Axa series mobile power amplifiers

Seite drucken
Problem
Unit will not turn on
(no power LED
indicator)
Unit has power - LED is
green (but no sound)
Unit blows fuse(s)
Engine noise
LED illuminates red
(protect mode)
Distorted audio output
Low audio output
Weak bass
OPERATION

Troubleshooting

Cause
+12V wire not connected or incorrect
voltage
REM wire not connected or incorrect voltage
GND wire not connected
Fuse(s) blown
Speaker wires not connected
Volume turned all the way down
One or more speaker wires touching each
other or touching chassis ground
Speaker(s) defective or damaged
Input signal not connected
Incorrect fuse rating
+12V wire touching chassis ground
Speaker(s) defective or damaged
Bad ground connection
Signal ground loop or RFI (radio frequency
interference)
One or more speaker wires touching each
other or touching chassis ground
Speaker(s) defective or
damaged internally (shorted)
Speaker load less than 2 ohms (stereo)
Speaker load less than 4 ohms (bridged)
Incorrect input signal type or
input level too high
Incorrect input signal type or
input level too low
Speaker(s) are wired out of phase
Action
Check connections for proper voltage
(11~16VDC)
Check connection to ground
Replace fuse(s)
Check connections at speakers
Increase volume level at head unit
Insulate all bare speaker wires from each
other and chassis ground
Check/replace speaker(s)
Check high or low level inputs for proper
connection
Use fuse(s) with correct rating
Check for pinched wire
Check/replace speaker(s)
Make sure amplifier is grounded to clean
bare metal
Re-route RCA cables from existing high
current wiring
Insulate all bare speaker wires from each
other and chassis ground
Check/replace speaker(s)
Adjust speaker load - amplifier will not
operate at less than 4 ohms when bridged
Check connections and reduce/adjust
input level
Check connections and increase/adjust
input level
Check (+) and (-) speaker connections
(Observe correct polarity)
9