Epson 220 Handbuch - Seite 18

Blättern Sie online oder laden Sie pdf Handbuch für Drucker Epson 220 herunter. Epson 220 29 Seiten. Epson printer parts manual

EPSON LQ-2080

3. Lower the tractor into the printer mounting slots and

press down both ends of the tractor to make sure that it

is firmly seated.

You are now ready to load continuous paper onto the pull

tractor as described in the next section.

Loading paper onto the pull tractor

When using the pull tractor, load continuous paper in the

front or bottom slot, if possible; loading paper in the rear slot

may increase the chance of a paper jam.

To load paper onto the pull tractor, follow these steps:

1. Make sure the printer is turned off and the printer cover is

removed. Also check that a tractor is installed in the pull

position.

2. Slide the edge guides to the middle of the paper guide.

3. Set the paper release lever to the front push tractor position.

Then set the paper thickness lever to accommodate your

paper thickness.

18 - EPSON LQ-2080

4. Release the left and right sprockets by pulling the sprocket

lock levers forward.

5. Slide the left sprocket to the left margin of the paper using

the scale on the paper guide. (Printing starts at the arrow

mark.) Then push the lever back to lock it in place.

Note:

See "Paper Alignment" and "Printable Area" on page 5 for more

information on the left margin position.

6. Slide the right sprocket to match the width of your paper,

but do not lock it. Move the paper support midway between

the two sprockets as shown above. Then open both sprocket

covers.

7. Make sure your paper has a clean, straight edge.

2/99