Axxess AX-JP901 Installationsanleitung Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Automobilelektronik Axxess AX-JP901 herunter. Axxess AX-JP901 8 Seiten. Jeep renegade data interface with swc & factory display retention2015

Seite drucken

CONNECTIONS TO BE MADE

• For all other radios: Connect the 3.5mm jack from the ASWC-1 harness, into the jack on the

aftermarket radio designated for an external steering wheel control interface. Please refer to

the aftermarket radios manual if in doubt as to where the 3.5mm jack goes to.

• Connect the Yellow male RCA jack labeled "To Reverse Camera Input (Radio)", to the backup

camera input.

Note: The aftermarket radios backup camera input will be used to display the vehicle

settings. If the radio doesn't have a backup camera Input, then there will be no visualization

of the vehicle settings. An externally mounted screen could be substituted in this situation.

• If installing an aftermarket backup camera, connect the Yellow female RCA jack labeled "To

Reverse Camera", to the camera.

INSTALLING THE AX-JP901 INTERFACE

With the key in the off position:

• Connect the AX-JP901 harness to the AX-JP901 interface, and then to the wiring harness in

the vehicle.

• Tie wrap the chime speaker under the dash to a location where it will be heard clearly by

the driver, then route the harness to the radio location.

• Connect the chime speaker to the AX-JP901 Interface.

• Connect the ASWC-1 harness to the ASWC-1 interface, and then to the AX-JP901 interface.

PROGRAMMING THE ASWC-1 INTERFACE

(CONT.)

• Turn the ignition on, the L.E.D. in the ASWC-1 interface will start flashing rapidly, which

means the ASWC-1 is looking for the vehicle and the radio.

Note: If the L.E.D. did not start flashing rapidly, press the reset button for 3 seconds.

•

After a few seconds the L.E.D. should stop flashing rapidly, and then go out for approximately 2 seconds

• After approximately 2 seconds there will be a series of 7 Green flashes, some short, and

some long. The long flashes represent the wires that are connected to the ASWC-1. The 3rd,

4th, 5th, and 6th flashes should be longer.

Tip: Knowing this will help to troubleshoot, if need be.

• The L.E.D. will pause for another 2 seconds, and then flash Red up to 18 times depending on

which radio is connected to the ASWC-1. Refer to the L.E.D. feedback section for information.

• This is the end of the auto detection stage. If the ASWC-1 detected the vehicle and the radio

successfully, the L.E.D. will light up solid.

• Test the steering wheel controls for proper operation. Refer to the ASWC-1 instructions online

at axxessinterfaces.com for customizing the buttons, if so desired.

Continued on the next page

REV. 4/10/2018 INSTAX-JP901