Axxess GMOS-MOST-02 Installationsanleitung Handbuch - Seite 2
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Automobilelektronik Axxess GMOS-MOST-02 herunter. Axxess GMOS-MOST-02 9 Seiten. Gm most amplifier interface2014-up
Seite drucken
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
Note: If installing an ASWC-1 (sold separately), there will be an accessory wire there to
connect as well.
• Connect the Blue/White wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
• If also installing an ASWC-1 (sold separately), connect the Brown wire to the Brown wire in
the 12-pin pre-wired ASWC-1 harness.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
2
CONNECTIONS
From the GMOS-MOST-02 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Brown wire, to the Brown wire from the 16-pin harness with stripped leads.
• Disregard the Red wire, it will not be used in this application.
• Disregard the Red & White RCA jacks, they will not be used in this application.
12-pin pre-wired ASWC-1 harness:
This harness is to be used along with the ASWC-1 (sold separately) to retain steering wheel
audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be used,
please refer to the ASWC-1 instructions for radio connections and programming. Disregard
the harness that comes with the ASWC-1.
(Figure A)
• Connect the Red wire to the
Green/Black wire
accessory wire.
• Connect the Green/Black
wire, to the Green/Black wire
in the 10-pin Black connector
located in the steering
column. (Figure A)
Continued on the next page