DigiDesign FWx FireWire Handbuch - Seite 8

Blättern Sie online oder laden Sie pdf Handbuch für Aufnahmegeräte DigiDesign FWx FireWire herunter. DigiDesign FWx FireWire 18 Seiten.

Gently slide the card into the expansion slot. Make sure it is

oriented right-side up.

Installing the FWx card in the FOH Rack

When the card is seated in its slot, secure it to the FOH chas-

sis with the mounting screw at the end of the FWx mounting

bracket (accessible from the open front panel of the FOH

Rack).

Secure the FWx card to the back panel of the FOH Rack us-

ing the two screws that held the faceplate.

FWx

card

Securing the FWx Card to the back panel of the FOH Rack

Attach an available internal power cable plug to the power

socket on the FWx card by holding the socket on the FWx and

pushing the plug firmly into the socket.

When the power cable plug is correctly attached to the FWx

card, the yellow wire should be the first wire from the left.

FWx Record/Playback Option Card

Attach the included ribbon cable to the ribbon connector

socket labelled "FireWire" on the first Mix Engine card (the

rear most card when viewed from the open front panel). Make

sure that the ribbon cable connector's notch is facing you

when attaching the connector.

Attaching the ribbon cable to the Mix Engine card

Attach the other end of the ribbon cable to the ribbon con-

nector socket on the FWx card. Make sure that the notch on

the ribbon cable connector is facing upwards when attaching

the cable.

Attaching the ribbon cable to the FWx card

Reattach the FOH Rack faceplate using its screws.

Reconnect power, audio, FOH Link, and any MIDI cables to

the FOH Rack.

Power on all system components. Proceed to "Confirming

FOH Rack FWx Card Installation" on page 5.