Axxess TYTO-01 Installationsanleitung Handbuch - Seite 3
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Verstärken Axxess TYTO-01 herunter. Axxess TYTO-01 8 Seiten. Toyota digitalamplifier interface 2001-2015
Seite drucken
CONNECTIONS
From the TYTO-01 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Blue wire to the power antenna wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
INSTALLATION
With the key in the off position:
1. Connect the 16-pin harness with stripped leads, and the TYTO-01 harness into the interface.
2. Connect the TYTO-01 harness to the wiring harness in the vehicle.
(CONT.)
PROGRAMMING
1. Turn the key (or push-to-start button) to the ignition position and wait until the radio
comes on. The factory amplifier should come on and you should hear sound at this point.
2. Test all functions of the installation for proper operation, before reassembling the dash.
Note: To use fade, ensure the radio is turned up 3/4 of the way.
AUDIO LEVEL ADJUSTMENT
1. With the vehicle and radio turned on, turn the volume up 3/4 of the way.
2. With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio
level; counter clockwise to lower the audio level.
3. Once at a desired level, audio adjustment is complete.
3
REV. 11/28/2018 INSTTYTO-01