Epson ActionPrinter 2250 Handbuch - Seite 6
Blättern Sie online oder laden Sie pdf Handbuch für Drucker Epson ActionPrinter 2250 herunter. Epson ActionPrinter 2250 13 Seiten. Epson printer specification sheet
Seite drucken
ActionPrinter 2250
When you want to push the paper support back into the paper
l
cassette, first remove paper from the cassette. Then hold down
the locking tab while pushing the paper support in.
The default page length for the paper cassette is 65 lines (A4-size
l
paper) or 61 lines (letter-size paper). You can change it using
your software or printer commands, if necessary.
You can switch to manual insertion or to the push tractor
l
without removing the paper cassette.
Loading paper manually
You can load single sheets of paper from the rear manual insertion
slot. (if you've installed the push tractor, remove it before loading
paper manually.)
1. Place the printer in the upright position and turn it on.
2. Next, lower the flap on the rear slot. Then insert a single sheet
into the slot, aligning the paper edge with the arrow mark on the
printer case. The page loads automatically. When the printer
receives data, it begins printing.
tk sure to raise the flap when not using manual insertion.
Be sure to turn on the printer before you insert
CAUTION:
the page into the slot. If you bun on the printer after you
insert paper, the printer prints on the platen without
.
You can adjust the top-of-form position in the same way that
you do for paper loaded from the cassette.
When you want to switch to the paper cassette, press the
l
button without inserting a page into the rear slot. The printer
loads a page from the cassette.
AP-2250-6
Using continuous paper with the push tractor
You can use the push tractor to print on continuous paper from
101 mm (4 inches) to 254 mm (10 inches) wide.
Note: The tractor is an option (part number C80026*).
Installing the push tractor
1. Make sure the printer is turned off and is in the flat position.
Remove the paper guide.
2. Make sure the paper-release lever on the left side of the push
tractor
lowered to the single-sheet position.
is
3. Hold the tractor as shown and fit the edges of both
slots at the back of the printer. Then lift it straight up until
hear the
unit snap into
4. Raise the paper-release lever and push it firmly into the
continuous-paper position.
LF/FF
7/l 4/92
sides
place.
9-Pin Printers
into the