Epson AcuLaser C8600 Kurzreferenz - Seite 9
Blättern Sie online oder laden Sie pdf Kurzreferenz für Drucker Epson AcuLaser C8600 herunter. Epson AcuLaser C8600 23 Seiten. Epson aculaser c8600: specifications
Auch für Epson AcuLaser C8600: Setup-Handbuch (44 seiten), Spezifikationen (1 seiten)
Seite drucken
Ready
The printer is ready to receive data and print.
Replace Photoconductr
The photoconductor unit has reached the
end of its service life. Turn off the printer,
then replace the photoconductor unit with a
a new one. See "Photoconductor Unit" in the
Reference Guide for instructions.
The error clears automatically after you
replace the unit and close all printer covers.
The photoconductor service life counter is
reset automatically.
Replace Waste T Box
The waste toner collector is full of toner.
Replace it with a new waste toner collector.
See "Replacing the waste toner collector" in
the Reference Guide.
The error clears itself after you have replaced
the waste toner collector and close the front
cover.
Reserve Job Canceled
The printer cannot store the data of your
print job using the Reserve Job function. The
maximum number of print jobs stored in the
printer's Hard Disk Drive has been reached,
or the drive has no more memory available
to store a new job. To store a new print job,
delete a previously stored job. Also, if you
have any Confidential Jobs stored, printing
those jobs will make more memory
available.
To clear this error, select Clear Warning
from the control panel's Reset Menu. See
"How to access the control panel menus" for
instructions.
EPSON AcuLaser C8600 Quick Reference
Reset
The printer's current interface has been reset
and the buffer has been cleared. However,
other interfaces are still active and retain
their settings and data.
Reset All
All printer settings have been reset to the
default configuration, or to the last settings
that were saved.
Reset to Save
A control panel menu setting was changed
while the printer was printing. Press the
Start/Stop button to clear this message. The
setting will become effective after printing
has finished.
ROM Check
The printer is checking the ROM.
Self Test
The printer is performing a quick internal
check.
Service Req xyyy
A controller error or a print engine error has
been detected. Turn off the printer. Wait at
least 5 seconds and then turn it back on. If
the error message still appears, write down
the error number listed on the LCD panel
(xyyy) and turn off the printer, unplug the
power cord, and contact a qualified service
representative.
Standby
The printer is in stand-by mode.
Status and Error Messages (6/8)