Creda Non pumped Installations- und Benutzerhandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Installations- und Benutzerhandbuch für Sanitärprodukt Creda Non pumped herunter. Creda Non pumped 10 Seiten. Thermostatic digital mixer shower electronic remote control mixer shower
Seite drucken
Remove battery cover and insert 2 x AAA batteries. (Observe polarity).
Ensure the rubber seal is correctly located before replacing the battery cover.
Additional remote control
•
More than one remote control can be configured to the same base unit.
•
Only one remote control will function at any one time.
(See spares for additional remotes : Page 19)
_14_
High pressure – Unvented thermal store (Non Pumped Model only)
High pressure – Combi boiler (Non Pumped Model only)
• Pressure reducing valves are required if
the pressure is above 5 bar.
• This plumbing scheme requires that the
hot water pipe to the base unit (Non
Pumped) MUST come from the output
of a combi boiler.
• The cold water supply MUST come
from a balanced pressurised supply.
• When a combi boiler scheme is used,
DIP 4 switch (inside remote control
battery compartment) MUST be set to
Off.
See "Fix the flow rate (no flow
adjustment possible)" on Page 11
Diagram of un-vented combi boiler
system
Shower cubicle
•
The mixed outlet pipe from the base unit is connected to the shower accessories in the shower
cubicle. (See separate installation instructions supplied with the accessories)
•
Fix the remote control holder in the required position.
(Avoid mounting the remote control in the direct spray from the shower handset)
•
Pressure reducing valves are required if
the pressure is above 5 bar.
•
This plumbing scheme requires that the
hot water pipe to the base unit (Non
Pumped) MUST come from the output of
the thermal store.
•
If required, a temperature blending valve
can be fitted on the hot outlet of the
thermal store.
•
The cold water supply MUST come from
a balanced pressurised supply.
Diagram of un-vented thermal store system
_7_