Aybey Elektronik CCL-P Programmier- und Installationshandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Programmier- und Installationshandbuch für Monitor Aybey Elektronik CCL-P herunter. Aybey Elektronik CCL-P 5 Seiten. Custom design rgb lcd display board
Seite drucken
PROGRAMMING
On board, there are 3 buttons named as INC (↑), DEC (↓) and ENT. ENT button is used to enter and
exit to/from programming mode, to approve and to save settings. INC (↑) and DEC (↓) buttons are
used to increase and decrease current value and move up and down in menu.
FLOOR DISPLAY SETTINGS (Only in Parallel Mode CCL-P)
Push and hold ENT button a few second to enter programming mode where arrows and busy icon
always blink to distinguish it from normal mode. Floor number blinks and firstly change floor number
with INC (↑) and DEC (↓) buttons to set. Then with ENT button, right display, left display, display
color and signals colors can be select and set with INC (↑) and DEC (↓) buttons respectively.
This display shows upper menu of Floor 0 (bottom floor). To edit Floor 0 display data, push ENT
shortly and enter sub-menu.
Here right char blinks. Now it can be changed by pushing INC (↑) and DEC (↓) buttons. Any number
or letter can be chosen. After selecting right char, push ENT shortly and left char starts to blink. In the
same way left char is set. Then select floor and signal color by pushing ENT and change with INC (↑)
and DEC (↓) buttons. If no color selected to signals, then floor color displays.
After setting displays, push and hold ENT button for a few seconds, then all setting are saved into
permanent memory. At any step of programming it is possible to save changes and exit in the same
way. Now display turns to normal mode and shows current floor info.
SET AS A SINGLE COLOR TO ALL FLOORS
If single color is desired in all floors and signals, then set floor 0 to desired color and push and hold
ENT and DEC (↓) buttons both to save settings to permanent memory.
F/7.5.5.02.89 R:2
CCL
3