CREE LIGHTING EDGE Series Installationsanleitung Handbuch

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Außenleuchte CREE LIGHTING EDGE Series herunter. CREE LIGHTING EDGE Series 6 Seiten. Led pathway

Seite drucken

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed

including the following:

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS

DANGER- Risk of shock- Disconnect power before installation.

DANGER – Risque de choc – Couper l'alimentation avant l'installation.

This luminaire must be installed in accordance with the NEC or your local

electrical code. If you are not familiar with these codes and requirements, consult

a qualified electrician.

Ce produit doit être installé conformément à NEC ou votre code électrique local.

Si vous n'êtes pas familier avec ces codes et ces exigences, veuillez contacter un

électricien qualifié.

SAVE THESE INSTRUCTIONS FOR

FUTURE REFERENCE

TO INSTALL:

1 of 3

THE EDGE

INSTALLATION INSTRUCTIONS

INSTRUCTIONS D'INSTALLATION

REMOVING EXISTING BOLLARD

STEP 1:

To remove existing Bollard Pole from anchor

bolts, remove four 1/4-20 flat head screws at

base of pole and lift off pole and lens assembly

vertically. See Figure 1.

STEP 2:

Disconnect electrical supply connections.

STEP 3:

Remove nuts and jam nuts from anchor bolts

and set aside. Remove the inner frame assembly

and 8" base plate from anchor bolts.

INSTALL PATHWAY

STEP 1:

Remove 4" base plate from bottom of new

Pathway pole by removing three 1/4-20 flat head

screws at base of pole. See Figure 2.

STEP 2:

Connect 4" Pathway Base to steel transition

plate supplied in Retrofit Kit by inserting three

3/8 x 2.00 flat head screws up through the steel

plate and up through the bottom of the base.

Figure 3.

Secure with nuts. See

STEP 3:

Position the transition plate over existing anchor

bolts and secure with nuts set aside from Step 3.

STEP 4:

Attach L bracket to hole in transition plate using

#8 x 0.25 screw.

STEP 5:

Loosen 3/8-16 pan head screw located at the

arm base of optic assembly using a T-45 torx

Figure 4.

socket and ratchet. See

STEP 6:

Lift optic assembly from pole.

LED Pathway

Includes: XBP

CI347X02R1_B