CREE LIGHTING Stylus Series Installationsanleitung Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Arbeitslicht CREE LIGHTING Stylus Series herunter. CREE LIGHTING Stylus Series 8 Seiten.

Seite drucken

Flexible Conduit

Supplied By Others

Support Nut

Supplied By Others

LED Tray

Lens

4.25"

Ceiling opening width

for Flangeless

Sheetrock Mud

Supplied By Others

6 of 8

Threaded Support Rods Supplied By Others

3.37"

Ceiling opening width

overlapping flange

Threaded Support Rod

Supplied by Others

Sheetrock Mud

Supplied By Others

SECTION 3:

OFF GRID MOUNTING (HARD CEILING) -

INDIVIDUAL RECESSED MOUNTING

CAUTION: Ceiling contractor must provide an uninterrupted,

continuous rough opening. Dimensions of opening should be

determined using Figure 3 on page 3 and Figure 9.

CAUTION: Luminaires should be secured to structure above

using customer supplied threaded rods to support weight of

luminaire.

STEP 1:

Remove lens and LED/reflector tray and set aside in order

of run placement for reinstalling later. To remove lens,

carefully slide a plastic card or putty knife between the lens

and extrusion towards the end of the luminaire. Using the

plastic card or putty knife, push the lens inward until the

lens come free. After removing the lens, remove the Philips

head reflector screws, remove the LED Reflector Tray, and

disconnect the LED harness. Set lens and LED Reflector tray

aside. See Figure 2 and 8.

STEP 2:

Using one of the 7/8" dia. holes on the end of the fixture,

install conduit connector. See Figure 8.

STEP 3:

Install fixture from below into ceiling opening. Attach

customer supplied threaded rods to luminaire through 5/8"

mounting holes located on the top of the housing and to the

structure above as shown in Figure 8. Confirm that fixture is

pulled up firm to ceiling line.

STEP 4:

Make electrical connections per Section 5 "Electrical

Connections" to leads in wiring compartment.

STEP 5:

Reconnect LED harness. Replace LED trays and lens that

was removed in Step 1 above, ensure that no wires are

pinched.

STEP 6:

For Hard Ceiling, Overlap Flange Only:

Fill in Sheet Rock mud over tapered extruded flange until

smooth. See Figure 10.

#10-18 X 1/4"

Phillips Head Screws

LPN00644X0007A0_A