Creek Company ODC 1018 Montageanleitung Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Boot Creek Company ODC 1018 herunter. Creek Company ODC 1018 6 Seiten.

Your ODC Outdoor Discovery Craft is designed to give you many years of service.

IF YOU EVER HAVE ANY QUESTIONS OR PROBLEMS WITH YOUR ODC 1018 PLEASE DO NOT

RETURN IT TO THE DEALER YOU BOUGHT IT FROM. PLEASE CONTACT THE CREEK COMPANY

DIRECTLY TOLL FREE AT 1-800-843-8454. WE ARE OPEN M-F 9AM-5PM MOUNTAIN TIME. OR CONTACT US

HIN

1. Always wear a US Coast Guard approved personal floatation device when in your ODC 1018.

2. Never float alone.

3. Always check your ODC 1018 air bladders, frame, oar components, and covers for possible damage

before you use your craft.

4. Never use your craft if you suspect the air bladders, frame, oar components, or cover has been damaged.

5. Never over inflate your ODC 1018.

6. Never use your ODC 1018 without the pontoons fully inflated.

1. If your pontoon bladder is losing air, please check that valve assembly and top valve cap are fully seated. Reseat valve

assembly and repeat pontoon inflation instructions.

2. Do not store your ODC 1018 in direct sunlight.

3. If you are leaving your ODC 1018 out in the sun for any amount of time, be aware that the heat can increase the

pressure inside the pontoons to a dangerous level. Let some of the air out of the pontoons if the craft will be out of the water

in the sun for any length of time, or if it is stored in a vehicle, etc.

4. A gain in altitude will increase the pressure in the pontoons also. If you are taking your inflated ODC 1018 from

a low elevation to a high elevation, be sure to let some of the air out of it.

5. For short term storage, we recommend you let some air out of your pontoons.

6. For long term storage, we recommend you make sure your ODC 1018 is completely dry, deflated and stored out of

the sunlight in a cool dry area.

7. Repairing bladder, use enclosed patch kit. Fully deflate bladder. Remove safety split-ring from zipper pull and open

zipper in pontoon cover. Remove bladder from inner liner. Identify puncture. Clean and dry area around puncture.

Apply glue to puncture area and patch using applicator straw. Press patch over punture area and patch using appllicator

straw. Allow 24 hours to dry dry before Inflation.

8. Note: Metal parts may rust and are not covered under warranty.

Accessories are available for your ODC 1018. Ask for them where you bought your ODC 1018,

The Creek Company Ltd. , PO Box 773892, Steamboat Springs, CO 80477

All Creek Company products are guaranteed against defects in material and workmanship for the life of the product to

the original owner. This does not cover damage due to misuse or normal wear and tear.

ODC 1018

O O U U T T D D O O O O R R D D I I S S C C O O V V E E R R Y Y C C R R A A F F T T

Please follow inflation instructions and warnings carefully.

IS LOCATED ON SQUARE TUBING OF SEAT SUPPORT FRAME MEMBER

Warning:

AND ON RIGHT MAIN FRAME MEMBER (SEE FIGURE 4)

Please read and follow carefully.

CARE AND MAINTENANCE:

or visit the Creek Company Store at www.creekcompany.com

Specifications and other details subject to change without notice.

T T M

T T M M