Creek Company ODC 616 OUTDOOR DISCOVERY CRAFT Montageanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Montageanleitung für Boot Creek Company ODC 616 OUTDOOR DISCOVERY CRAFT herunter. Creek Company ODC 616 OUTDOOR DISCOVERY CRAFT 4 Seiten.

Seite drucken

Your ODC Outdoor Discovery Craft

IF YOU EVER HAVE ANY QUESTIONS OR PROBLEMS WITH YOUR ODC 616

RETURN IT TO THE DEALER YOU BOUGHT IT FROM. PLEASE CONTACT THE CREEK COMPANY

DIRECTLY TOLL FREE AT 1-800-843-8454. WE ARE OPEN M-F 9AM-5PM MOUNTAIN TIME. OR CONTACT US

HIN

IS LOCATED ON SEAT SUPPORT FRAME MEMBER AND ON RIGHT MAIN FRAME MEMBER (SEE FIGURE 1)

1. Always wear a US Coast Guard approved personal flotation device when in your ODC 616

2. Never float alone.

3. Always check your ODC 616

4. Never use your craft if you suspect the Air Bladders, outer skin or stitching has been damaged.

5. Never overinflate your ODC 616

6. Never use your ODC 616

™

7. Your ODC 616

is not designed for use in salt water.

1. If your Pontoon Bladder is losing air, please check that Valve Assembly and Top Valve Cap are fully seated. Reseat valve

assembly and repeat pontoon inflation instructions.

2. Do not store your ODC 616

3. If you are leaving your ODC 616

inside the Pontoons to a dangerous level. Let some of the air out of the pontoons if the craft will be out of the water in the sun for

any length of time, or if it is stored in a vehicle, etc.

4. A gain in altitude will increase the pressure in the Pontoons also. If you are taking your inflated ODC 616

elevation to a high elevation, be sure to let some of the air out of it.

5. For short term storage, we recommend you let some air out of your Pontoons.

6. For long term storage, we recommend you make sure your ODC 616

sunlight in a cool dry area.. Do not store your wet ODC 616

other component damage.

7. Repairing Bladder, use enclosed patch kit. Identify puncture. Fully deflate Bladder. Clean and dry area around puncture. Apply

glue to puncture area and patch using applicator straw. Press patch over puncture area. Allow 24 hours to dry, before inflating.

8. Note: Metal parts may rust and are not covered under warranty.

Accessories are available for your ODC 616

The Creek Company Ltd. , PO Box 773892, Steamboat Springs, CO 80477

All Creek Company products are guaranteed against defects in material and workmanship for the life of the product to

the original owner. This does not cover damage due to misuse or normal wear and tear.

ODC 616

O O U U T T D D O O O O R R D D I I S S C C O O V V E E R R Y Y C C R R A A F F T T

Please follow inflation instructions and warnings carefully.

VIA E-MAIL AT [email protected].

Warning:

Please read and follow carefully.

™

Air Bladders, outer skin and stitching for possible damage before you use your craft.

™

without the Pontoons fully inflated.

CARE AND MAINTENANCE:

™

in direct sunlight.

™

out in the sun for any amount of time, be aware that the heat can increase the pressure

or visit the Creek Company Store at www.CreekCompany.com

email: [email protected] • Made in China

Specifications and other details subject to change without notice.

™

is designed to give you many years of service.

™

is completely dry, deflated and stored out of the

™

in freezing temperatures as this may result in Frame and

™

. Ask for them where you bought your ODC 616

T T M M

™

PLEASE DO NOT

™

from a low

™