Ayre T-series Installationsanleitung Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Klimagerät Ayre T-series herunter. Ayre T-series 16 Seiten. T-series split system air conditioner

Seite drucken

3. Split type installation

3.1 Select the best location

3.1.1 Indoor unit

1) Do not have any heat or steam near the unit.

2) Select a place where there are no obstacles in front of

the unit.

3) Make sure that condensation drainage can be conve -

niently routed away.

4) Do not install near a doorway.

5) Ensure that the space around the left and right of the

unit is more than 5cm. The unit should be installed as

high on the wall as possible, allowing a minimum of

5cm from ceiling.

6) Use a stud finder to locate studs to prevent unneces -

sary damage to the wall.

More than 5cm

More than 2.3m

CAUTION

Install the indoor unit on the wall where the height from the

floors more than 2.3 meters.

3.1.2 Outdoor unit

1) If an awning is built over the unit to prevent direct sun -

light or rain exposure, make sure that heat radiation

from the condenser is not restricted.

2) Ensure that the space around the back and sides is

more than 10cm. The front of the unit should have

more than 70cm of space.

3) Do not place animals and plants in the path of the

warm air.

4) Take the air conditioner weight into account and select

a place where noise and vibration are minimum.

5) Select a place so that the warm air and noise from the

air conditioner do not disturb neighbors.

More than 10cm

More than 70cm

More than 5cm

More than 60cm

More than 10cm

than 60cm

Installation Instructions • T-series Split System Air Conditioner

6) Rooftop Installations:

If the outdoor unit is installed on a roof structure, be

sure to level the unit. Ensure the roof structure and

anchoring method are adequate for the unit location.

Consult local codes regarding rooftop mounting.

3.2 Piping length and elevation

Pipe Size

Capacity

(kW)

GAS LIQUID

2.7kW

3/8"

1/4"

3.2kW

1/2"

1/4

5.0kW

1/4"

4.5

7.0kW

5/8"

3/8"

* Both gas and liquid interconnecting pipes must be

insulated as a pair, but it is not necessary to indi -

vidually insulate them.

Indoor unit

Oil trap

Indoor unit

In case more than 5m

CAUTION

• Capacity is based on standard length and maximum allowance

length is on the basis of reliability.

• Oil trap should be installed every 5~7 meters.

Page 2

Standard

Max.

Additional

Length

Elevation

length

Refrigerant

(m)

3 or 5

3.5 or 5

Outdoor unit

(g/m)