Digilent chipKIT DP32 Referenzhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Referenzhandbuch für Hauptplatine Digilent chipKIT DP32 herunter. Digilent chipKIT DP32 18 Seiten. Board
Auch für Digilent chipKIT DP32: Referenzhandbuch (10 seiten)

Seite drucken
Digilent chipKIT DP32 Referenzhandbuch
12/21/2018
4. Open that application and click "Install Drivers". You may need to allow admin permission for it to complete.
5. Once the drivers are installed, close the windows. Open MPIDE, connect the board with the USB cable, and allow Windows to
find and install the correct drivers.
Once the driver is installed and the computer has recognized the board, it is ready to be programmed. The board has two modes of
operation. The first is the bootloader mode, to enter this mode you must press and hold down BTN2/PGM button while pressing the
RESET button then release both to set the board into program mode. In program mode LD1 will flash to show you that the bootloader
is running and the board is ready to be programmed.
Once the board is programmed it will be reset and will execute the programmed sketch. If there is a sketch loaded on the board and you
cycle power to the board, it will automatically reenter sketch mode. Each time you edit your sketch and need to reload it to the board,
you will need to exit sketch mode by pressing and holding BTN/PGM, pressing RESET, and then releasing both to re-enter program
mode.
Since the board resets between program mode and sketch mode the serial port will disconnect and then reconnect. The MPIDE serial
monitor will not work unless there is a delay of at least 5 seconds in the user sketch before it begins to send data to the computer. To
ensure the serial monitor is ready it is recommended that users watch the device manager or similar program for your OS () after the reset
to watch for the reconnection of the serial port before attempting to open the Serial Monitor in MPIDE. The delay is required for proper
operation of the serial port so that the board can disconnect and reconnect to the computer before the DP32 begins sending data out
while the OS () is not listening. This is a byproduct of the embedded USB controller solution on the DP32.
3.2 Microchip MPLAB IDE Development Tool Campatibility
https://reference.digilentinc.com/chipkit_dp32/refmanual
chipKIT DP32 Reference Manual [Reference.Digilentinc]
6/17