FIAMA F8P Benutzerhandbuch und Wartung - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch und Wartung für Industrieller Monitor FIAMA F8P herunter. FIAMA F8P 9 Seiten. Display panel mount for magnetic band with battery power supply

Seite drucken
Display panel mount for magnetic band
The range allowed is from 0,00001 to 999999 with setting of decimal point position that is, after
programming of the last digit on the left, pressing key
key
it can be moved to the wanted position. Confirm with
Number of decimal digits
It is the number of decimal digits to visualize on the display, range allowed from 0 to 4.
Example: for every 10mm of linear displacement it is necessary to display 12.3456 with only two
decimal places: Set
Keys opening mode
This parameter programmes the functions linked to the keys.
The value to set is a number of three digits so each key corresponds to a digit; the digit on the
right stands for setting of key
the left stand for key
The values allowed are the following:
VALUE
0
1
2
3
4
5
6
7
8
* Delayed means that to activate the function (reset or preset), it is necessary to keep
/
pressed for approximately 3 s.
ENTER
RESET
Reset: reset function of the displayed value; after pressing
set to zero.
Preset: preset function of the displayed value; after pressing
becomes equal to the value in the
(when the digit on the right is set to 2).
Fast Preset: the fast setting of the displayed value on the display; after pressing
appears and pressing 2 times
and then confirm with
corrected often.
Origin change (correction of the displayed value for tool changes): with this function 3 different
origins (0,1,2) can be set and with
After setting 4 in the first digit on the right of the
pressing 2 times
ENTER
radius of cutter 0), which is then confirmed by pressing
Now
will appear which is the nominal value for tool 1 (for example the radius of cutter 1): set
the correct value and confirm with
Finally
will appear which is the nominal value for tool 2 (for example the radius of cutter 2):
set the correct value and confirm with
Data: 13/01/16
=12,3456 and
=2
, the digit in the middle stands for key
RESET
.
Not active
mm/inch conversion
Not active
Not active
Not active
Not active
Not active
Not active
Not active
parameter, which can be set immediately after
/
ENTER
RESET
/
). This function is useful when the displayed value must be
ENTER
RESET
/
ENTER
RESET
/
it is possible to set the nominal value for tool 0 (for example the
RESET
/
ENTER
RESET
/
ENTER
RESET
F8P_ing.doc
will blink the decimal pinpoint and with
.
RESET
Not active
abs/rel
measurement
Not active
Not active
Not active
Not active
Not active
Not active
Not active
/
ENTER
ENTER
it is possible to set the value directly (use
it is possible to switch from one origin to another.
parameter,
/
.
ENTER
RESET
.
.
while the last digit on
/
ENTER
RESET
Not active
Reset
Preset
Fast Preset
Change of origin
0,1,2
Offset
Fast Offset
Delayed reset *
(after 3s)
Delayed preset *
(after 3s)
, the displayed value is
RESET
/
, the displayed value
RESET
ENTER
will appear and after
F8P
/
RESET
and
pag 4/9