Crescendo audio BC2000D Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Crescendo audio BC2000D herunter. Crescendo audio BC2000D 8 Seiten.

12V ( POWER CONNECTION )

Before mounting amplifiers, disconnect the negative ( - ) cable from your grounded battery to protect any

accidential damage to your awesome amplifiers and audio system.

BC amplifiers are designed to use 0 gauge power and ground connection.

Connect the power cables to power terminal + 12V.

BC amplifiers are not equipped with fuses because they do not like to be bossed around.

External fuses should be used.

Connect one end of fuse holder to the power cable going into the amplifiers and the other end of fuse holder to

positive battery.

This fuse location will protect the system and the vehicle against the possibility of a short circuit in the power cable.

Be sure to use fuses and fuse holder adequate for the application.

REM ( REMOTE )

Run a remote turn on cable ( at least 18 gauge ) from the switched + 12V source .

This may be a toggle switch, a relay, your source unit's remote trigger cables, or power antenna trigger cable.

Connect the remote turn on cable to the REM ( remote ) terminal.

GND ( GROUND )

Locate a secure grounding connection as close to amplifier as possible.

Make sure the location is clean and provides a direct electrical connection to the frame of the vehicle.

The ground needs to have as low of a resistance as possible.

Connect one end of a short piece of the same size cable as the power cable to the grounding point or to

one of your batteries or battery bank.

Run the other end of the 0 gauge cable to the mounting location of the amplifiers for connection to the

amplifiers ground terminals and connect the ground cable to the GND ( ground terminal ).

+12V SOURCE

Remote Turn on

Ground

BATTERY