Crescent SC6000 Benutzer- und Wartungshandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Benutzer- und Wartungshandbuch für Schrubber Crescent SC6000 herunter. Crescent SC6000 2 Seiten.
Auch für Crescent SC6000: Handbuch zur Fehlersuche (2 seiten)
Seite drucken
ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual.
1. Check the battery charge gauge
(and if necessary re-charge)
6.Install squeegee
11.Install Brushes.
16.Adjust detergent flow.
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to
carry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
2. E-stop icon that appears on display
when E-stop switch is engaged.
Twist E-stop switch to enable
machine function
7. Check the height of the squeegee by
adjusting the castor wheels and the
angle knob.
12.Adjust side skirts height
17.Press "I" scroll down to faults and
press ">" button to view faults
3. Check battery cables are well
connected together
8. Open broom door compartment and
check presence of ropes or debris
that can block it.
13.Lift side skirts when double
scrubbing is needed
4. Recovery tank seal cover must
correctly installed and in good
condition
9. Check presence of water in the
solution tank.
14. M ake sure that deck and squeegee
are moving down when pressing
the button.
www.crescentindustrial.co.uk
SC6000
5. Inspect the squeegee blades for cuts
or chunks
10. If necessary open the solution filter
cage and clean the net.
15.Adjust water flow.