Crescent C2000 Gebrauchsanweisung - Seite 2
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Hebesysteme Crescent C2000 herunter. Crescent C2000 2 Seiten. Body lift
Seite druckenTO RAISE HYDRAULIC LIFT
1
2
A
B
TO RAISE ELECTRONIC LIFT
1
2
!
C
D
CAUTION:
•Never raise arm above parallel to the floor, doing so
could cause lift to tip, causing damage or injury.
•Never lift using only one end of CRADLE.
•Always lower slowly.
TO LOWER HYDRAULIC LIFT
1
E
TO LOWER ELECTRONIC LIFT
1
2
F
F2
Tighten RELEASE VALVE clockwise
with tip of JACK HANDLE.(A)
Begin raising by pumping
JACK HANDLE in a smooth up and
down motion.(B)
Twist and pull out emergency stop(C)
Push and hold UP BUTTON on
remote until lift has attained proper
height, then release to stop.(D)
Slowly loosen RELEASE VALVE
counter-clockwise with tip of
JACK HANDLE, turning back
clockwise to lock into place.(E)
Make sure emergency stop is
disabled.(F)
Push and hold DOWN BUTTON on
remote until lift has lowered to proper
height, then release to stop.(F2)
ATTACHING BUCKLE TO 6' STRAPS
1
2
G
H
HOW TO USE STRAPS
1
2
!
I
3
For use with large bodies where it is difficult to place strap under body. Attach "S" hook to
Strap-Slider as shown above. Then, turn Strap-Slider over with strap side down and slide
under body. From opposite side, grab Strap-Slider & pull hook through to the other side.
LIFTING A CASKET
1
J
TO MOVE THROUGH DOORWAYS
1
Making sure CRADLE is supported, pull BALL &
PIN from CRADLE. Raise ARM to horizontal
position.Then, hang CRADLE on ARM.
2
Pull both BALL & PINS from LEGS and flip up.
3
Lift is now ready to roll through doorway.
Feed SIX FOOT STRAP end from
the underside into buckle.(G)
Loop STRAP end over BUCKLE
TEETH back through buckle.(H)
Place STRAPS under body.*
Hook both "S" HOOKS into slots
on CRADLE.(I)
•Never lift using only one end of CRADLE.
Pull tight at buckle for desired
length.
*STRAP
SLIDER
Feed 2 SIX FOOT STRAPS into
buckle at the same time(J). Then
proceed with same directions used in
lifting a body.
Electronic Model Shown