Cresco 10W Assembly

Blättern Sie online oder laden Sie pdf Assembly für Streuwagen Cresco 10W herunter. Cresco 10W 2 Seiten.

Seite drucken

Empty all contents of the box onto a ﬂat surface and count parts to make sure all are there.

You will need a phillips head screwdriver,

one pair of plyers/grips and an m6 metric

spanner.

Take the stand (Item 3) and place it onto

the protruding M6x60 bolts (x4) (Item ).

Tighten with the M6x30 lock nuts (x4)

(Item 1 ).

Feed the axel ( ) through the hole (without bearing) on the

lower legs. Push it through the gearbox and bearing (Item 5)

on the other side.

ASSEMBLING THE LOWER FRAME AND STAND:

Take the two lower frames (Item 14) and

attach them to the hopper body (Item 16)

using the M6x60 bolts (Item 10).

Spin the hopper body (Item 1 ) round as

shown. Place the gear box and impellor

(item 4) in the centre hole of the hopper

body (Item 1 ), let it rest there. Make sure

the arrow on the gearbox faces forwards.

Place both wheels (Item 1) onto the ends of the axel (Item 3).

Assembly of Cresco 10

CRESCO 10 PARTS LIST:

Plastic Wheel (X2)

Handle Bar

Stand

Gear box and Impellor

Axle bearing (X2) (One is

on the axle, the

Plastic Wheel Caps

Wheel Cap Screws

Agitator

M6x60 (X4)

M6 Nuts (X4)

NOTE

When placing the legs on the hopper, make sure

the two holes on the side of the lower frame

(item 1 ) are on the outside. There should be

one hole on the inside.

ASSEMBLING THE WHEELS:

Place one axel bearing (Item 5) into the hole

shown at the bottom of the lower frame

(1 ).

M6x50 (X2)

M6 x Wing Nut (X2)

Plastic Wheel Axle

(With part 5 attached)

Lower Frame (X2)

Control Rod

Hopper Body

Control Lever

Slider

Adjustor