ABB ScreenMaster RVG200 Handbuch - Seite 14
Blättern Sie online oder laden Sie pdf Handbuch für Messgeräte ABB ScreenMaster RVG200 herunter. ABB ScreenMaster RVG200 17 Seiten. Paperless recorder terminal block failures
Auch für ABB ScreenMaster RVG200: Anweisungen für die Inbetriebnahme (17 seiten), Verfahren zum Auswechseln der Batterie (4 seiten), Handbuch (2 seiten), Dienstanweisung (2 seiten)
Seite drucken
14
S C R E E N M A S T E R R V G 2 0 0 / PA P E R L E S S R E C O R D E R | C I/ R V G 2 0 0/0 0 1 - E N R E V. A
... 6 Basic setup
Change the channel configuration
1 At the System Configuration page, press the Channels icon
to display the I/O Groups 1(6) Channels page.
2 Press the icon associated with the required Group 1 (6)
Channels (for example
dialog.
IMPORTANT (NOTE)
Use the
Channels in the same process group.
3 Press the
tab and then the
Setup
each field to enter and configure Setup parameters – press
to accept the content at each field.
4 Repeat for all other tabs on the Channel 1.01 (1.06) dialog
and for all other required channels.
When all fields have been configured, press
the I/O Groups 1(6) Channels page then
the System Configuration page.
5 Proceed to the next section to set up the inputs / outputs
(I/O).
Set up the inputs / outputs (I/O)
1 At the System Configuration page, press the I/O icon
open an I/O page displaying fitted I/O modules.
IMPORTANT (NOTE)
I/O modules are detected automatically.
2 Press the icon associated with the required module to
display the dialog and fields associated with that module.
3 Configure parameters for each required module.
4 When all parameters have been configured, press
return to the I/O page then
Configuration page.
5 Proceed to the next section to exit Configuration level and
save changes.
) to display the Channel 1 (01 ...06)
arrows to select different
icon associated with
to return to
to return to
to return to the System
Save current configuration and exit
1 Press
at the System Configuration page – a prompt is
displayed with options to Apply Changes, Export
Configuration, Return to Configuration Mode or Discard
Changes:
System Configuration
Apply Changes
Export Configuration
Return to Configuration Mode
Discard Changes
2 Press Apply Changes (
configuration and return to the Operator page.
3 Proceed to the next section to start recording.
Start recording (archiving)
1 Open the media door and insert the external media card and
close the door.
Recording is initiated automatically.
to
to
IMPORTANT (NOTE)
Alternative archive media can be used – refer to
the Operating instructions (OI/RVG200-EN) for
compatible media types.
) to save the current