Cisco 1503 Software-Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Software-Handbuch für Schalter Cisco 1503 herunter. Cisco 1503 49 Seiten. Cisco systems switch user manual

Command Conventions

This section describes some things you might need to know before using the commands to

configure the hub. If you are familiar with these conventions, you can skip this section.

•

Enter commands by typing the text of the command at the configuration prompt and

then pressing the Return key.

•

There are two configuration prompt levels:

— The guest-level prompt is the device name followed by an angle bracket (>):

— The administrator-level prompt is the device name followed by a pound sign (#). To

•

There are two editing modes provided by the configuration program—normal and

enhanced. For more information about the enhanced editing mode, refer to the

terminal editing command in the section "Editing Commands" later in this chapter.

The following editing commands can be used on the command line in either editing

mode:

— Backspace erases characters to the left of the cursor.

— Delete erases characters to the right of the cursor (this may be different, depending

— Ctrl-C cancels a command prior to pressing the Return key.

— Tab or Ctrl-I completes a command name based on partial input.

Hub>

reach this prompt, the user (usually the system administrator) must enter a password

with the enable command:

Hub>

Hub> enable

Password: ******

Hub#

on the terminal emulation software that you are using).

Command Conventions

Using Your Hub Software 3-3