BYECOLD IGT1-HH0606-1 Gebrauchsanweisung - Seite 6

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Heizgerät BYECOLD IGT1-HH0606-1 herunter. BYECOLD IGT1-HH0606-1 9 Seiten. Infrared ceiling heater

Seite drucken
6┃INSTALLATION
Warning
•
Never install the device in a way that it radiates directly onto walls or other
objects. Observe the minimum distances from walls or other objects as
described in the following.
·A minimum distance of 180cm and a maximum distance of 270cm from the floor.
·A minimum distance of 100cm to the front or from objects.
·A minimum distance of 20cm to the sides.
• No any sticking ways are allowed to be used for hanging or suspending support!
• Ensure that mounting surface is capable of supporting the weight of the device.
• The device must be permanently installed by a licensed electrician in accordance
with local electrical codes. Assembly procedure must be performed with no
electrical power to unit.
• Power input cords must be connected or wired to those lines with switches which
can freely cut off the live lines!
• Make sure that the power cable is guided along the back of the device. Never
guide the power cable along the front of the device!
• Power input cords must be well grounded!
1.
Drill
4 holes on the ceiling with correct distance A and distance B.
Must use CORRECT
diameter drilling bit to avoid panel falling!
Panel Size/mm
595*595 (or similar)
1005*605(or similar)
1055*605(or similar)
1195*595 (or similar)
Note: 595 x 595 mm and 1195 x 595 mm size panel are also applicable to
the installation of suspended ceiling grid system.
2. Mount the 2 hanging hooks onto ceiling with screws, and turn the screws to the
end tightly. (This is very important).
3. Push the rear of the left long frame into the hook, and then push back to make
the rear of the right long frame into the other hook.
Note: 1.Hooks are for the two long frames only, not the two short ones!
2. Make sure the hooks are between the two limit screws !
Ceiling
PUSH
Panel
Left long frame
Hole Distances of Screws/mm
A485*B100mm
A495*B300mm
A495*B300mm
A485*B300mm
Panel
Right long frame
PUSH