Fiap 2850 Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Handbuch für Water Filtration Systems Fiap 2850 herunter. Fiap 2850 20 Seiten.

Seite drucken

FIAP Spalt Active

Information about this operating manual

Please read the operating instructions and familiarise yourself with the unit prior to using it for the first

time. Adhere to the safety information for the correct and safe use of the unit.

Intended use

The FIAP Spalt Active, in the following text termed unit, is exclusively intended for the mechanical

cleaning of garden ponds with or without fish population at a minimum water temperature of + 8 °C.

Ensure that the safety transformer is only operated at ambient temperatures of – 10 °C to + 40 °C.

The unit is suitable for use for swimming and bathing ponds in accordance with the national installer

regulations.

Use other than that intended

Danger to persons can emanate from this unit if it is not used in accordance with the intended use and

in the case of misuse. If used for purposes other than that intended, our warranty and operating permit

will become null and void.

CE Manufacturer's Declaration

We declare conformity in the sense of the EC directive, EMC directive (89/336/EEC) as well as the low

voltage directive (73/23/EEC). The following harmonised standards apply:

EN 60335-1, EN 61558-1, EN 61558-2-6, EN 55014-2, EN 61000-3-2, EN 61000-3-3

Safety information

For safety reasons, children and young persons under 16 years of age as well as persons who cannot

recognise possible danger or who are not familiar with these operating instructions, are not permitted

to use the unit!

Please keep these operating instructions in a safe place! Also hand over the operating instructions when

passing the unit on to a new owner. Ensure that all work with this unit is only carried out in accordance with

these instructions.

The combination of water and electricity can lead to danger to life and limb, if the unit is incorrectly connected

or misused.

Attention! Danger of electric shock. Ensure that the cable connection points and their surroundings

are dry.

The transformer and the plug connectors of the power cables supplied are not water-tight, but only rain and

splash-proof. Do not route or fit in the water! Protect the plug connection from moisture. Protect the

connection cable when burying to avoid damage. Only operate the unit when plugged into an earthed socket.

The latter must have been installed in accordance with the valid national regulations. Ensure that the

protective earth wire is led to the unit. Only use electrical equipment, adapters, extension or connection

cables with an earthed contact which are approved for outside use. Ensure that the power connection cable

cross section is not smaller than that of the rubber sheath with the identification H05RN-F. Extension cables

must meet DIN VDE 0620. Only use cables when unwound prior to use. Ensure that the unit is fused for a

rated residual current of max. 30 mA via a residual current-operating system (FI or RCD resp.). Electrical

installations in garden ponds and swimming ponds must meet the national and international regulations valid

for installers. Ensure that the safety transformer is located at a minimum spacing from the pond edge of 2 m

(in Germany) and 2,5 m in Switzerland. Compare the electrical values of the power supply with those on the

type plate on the packaging or on the unit itself. Never operate the unit if the cable or housing are defective!

Disconnect the power! Do not carry or pull the unit by the connection cable. Only use the unit with the

attendant safety transformer contained in our scope of delivery. Never open the unit housing or its attendant

components, unless this is explicitly mentioned in the operating instructions. Always disconnect the power

supply of all units located in water and of this unit prior to performing work on the unit! The power cable

Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045

FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen

Tel: 09628 9213 0; Fax: 09628 9213 30;

www.fiap.com

FIAP Spalt Active

cannot be replaced, if damaged. Never carry out technical changes to the unit. Only use original spare parts

and accessories. Only allow authorised customer service outlets to perform repairs. Never use the system for

filtering fluids other than water! Ensure that the filter will not overflow. Danger of completely emptying the

pond. For your own safety, consult an expert when you have questions or encounter problems!

Installation

Lay the outlet pipes for the water outlet into the pond and for the drain outlet into the sewage system or flower

bed with a sufficient gravity. Ensure that the unit is placed at a flood protected place and on firm ground.

When installing an FIAP UVC pre-clarifying unit (e.g. UV Active), place the unit at a minimum distance of 2 m

from the pond edge. Place the transformer at a minimum distance of 2 m from the pond edge at a flood

protected place. Ensure unrestricted access to the cover to be able to carry out work on the unit. Push or turn

the hose onto the stepped hose nozzle and secure with a hose clip. Lay the hose such that it will not deform

when walked on, avoid kinks and connect it to the pump.

Start-up

Switch on the pump. Close the cover. The unit functions automatically.

Note: The FIAP BioSieve Active filter is a mechanical- biological filter system and requires several weeks

after its first installation to reach its full biological effect.

The FIAP wedge wire screen filter is a low-maintenance and space saving filter for mechanical

water filtration in ponds and natural pools.

Pump- and gravity version

Outstanding good mechanical filtration

Effective oxygene enrichment under the FIAP wedge wire screen

Easy installation and maintenance

Filtrates pieces bigger than 300µ.

Suitable biomodules as a complete solution in the FIAP filter programm

Low nitrate and phosphate values by quick precipitation of dirt and excrement from the water cycle

Energy and water saving

Waste particle away from water circulation

Maintenance and cleaning

Adhere to the safety information given above! Always unplug the power cables of the pump prior to

starting work! Only clean the filter when required, do not use chemical cleaning agents to permit the

filter biology to optimally develop, knowing that cleaning agents kill the bacteria in the foam filters.

Storage/Over-wintering

Put the unit out of operation at water temperatures below 8 °C or, at the latest, when freezing

temperatures are to be expected. Drain and thoroughly clean the unit, check for damage. Do not

immerse the power plug in the water! Ensure that the storage place is inaccessible to children. Cover

the filter container such that the ingress of rain water is excluded. Drain all hoses, pipes and

connections as far as possible.

Wearing parts

FIAP SpaltSieb Active is a wearing parts and therefore not covered by our warranty.

Disposal

Dispose of the unit in accordance with the national legal regulations. Ask your specialist dealer.

Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045

FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen

Tel: 09628 9213 0; Fax: 09628 9213 30;