Cisco 3845 - Security Bundle Router Schnellstart-Handbuch - Seite 33
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Schalter Cisco 3845 - Security Bundle Router herunter. Cisco 3845 - Security Bundle Router 38 Seiten. Integrated services routers
Auch für Cisco 3845 - Security Bundle Router: Nicht-proprietäre Sicherheitspolitik (30 seiten), Handbuch zur Fehlersuche (15 seiten), Schnellstart-Handbuch (40 seiten)
Seite drucken
no ip routing
!
interface GigabitEthernet0/0
no shutdown
media-type 100BaseX
half-duplex
ip address 172.1.2.3 255.255.0.0
!
interface GigabitEthernet0/1
shutdown
no ip address
!
end
Step 10 Respond to the following prompts. Choose [2] to save the initial configuration:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
The user prompt appears:
Router>
Step 11 Verify the initial configuration. See the "Verify the Initial Configuration" section on page 34 for verification
procedures.
Initial Configuration Using the Cisco CLI—Manual Configuration
This section shows how to display a command-line interface (CLI) prompt for configuration using the CLI, and it directs you
to documentation for the CLI configuration. You can use the CLI if the following messages appear at the end of the startup
sequence:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
If these messages do not appear, SDM and a default configuration file were installed on the router at the factory. To use SDM
to configure the router, see the "Initial Configuration Using Cisco Router and Security Device Manager (SDM)" section on
page 30.
For help with interface and port numbering, see the "Port Numbering" section on page 29.
To proceed with manual configuration using the CLI, enter no when the power-up messages end:
Step 1
Would you like to enter the initial configuration dialog? [yes/no]: no
Press Return to terminate autoinstall and continue with manual configuration:
Step 2
Would you like to terminate autoinstall? [yes] Return
33