Cisco 4500-M Upgrade-Handbuch - Seite 8

Blättern Sie online oder laden Sie pdf Upgrade-Handbuch für Schalter Cisco 4500-M herunter. Cisco 4500-M 24 Seiten. Upgrading memory
Auch für Cisco 4500-M: Installationshandbuch (18 seiten), Ersatz-Handbuch (16 seiten)

Seite drucken

Removing Network Processor Modules

Warning

hands, to prevent it from falling. (See the hand in Figure 4.)

Step 6

Step 7

Proceed to the next section, "Removing Network Processor Modules."

Removing Network Processor Modules

If you are replacing shared memory single in-line memory modules (SIMMs), you must ﬁrst remove

the network processor modules. Follow the steps in this section to remove a network processor

module.

Caution

screws. On modules with external rear mounting screws, which include the Fiber Distributed Data

Interface (FDDI) module, these screws must be removed before the module can be safely lifted out

of the chassis, otherwise damage to the module will occur. Other types of modules may not have the

two external rear mounting screws attached to the chassis.

Step 1

Note

motherboards in the component tray. The motherboard was changed when the Cisco 4700-M was

introduced, and the new motherboard is also used in newer versions of the Cisco 4500-M.

Step 2

Caution

do not exert any side-to-side pressure because the handle might work loose and damage the network

processor module.

Figure 7 shows the network processor module and connector locations.

8 Upgrading Cisco 4500, Cisco 4500-M, Cisco 4700, and Cisco 4700-M Memory

Support the component tray from underneath, either on your work surface or with your

Pull on the handle located on the upper right corner of the chassis to slide the component

tray out of the chassis shell while you support the component tray with one hand.

Set the component tray on your work surface.

Some network processor modules are attached to the rear of the chassis with two external

With the component tray in front of you (as shown in Figure 5 and Figure 6), remove the

module mounting screw from the network processor module, and the two external rear

mounting screws (not shown) if the module has them, and set the screws aside.

The Cisco 4500, Cisco 4700, and older versions of the Cisco 4500-M use very similar

To lift the module out of its connector after removing the module mounting screws, grasp

the network processor module handle and pull straight up. (See Figure 7.)

Do not rock the handle up and down when handling the network processor module, and