Cisco 9134 - MDS Multilayer Fabric Switch Hardware-Installationshandbuch - Seite 14

Blättern Sie online oder laden Sie pdf Hardware-Installationshandbuch für Schalter Cisco 9134 - MDS Multilayer Fabric Switch herunter. Cisco 9134 - MDS Multilayer Fabric Switch 36 Seiten. Mds 9000 series
Auch für Cisco 9134 - MDS Multilayer Fabric Switch: Spezifikationen (3 seiten), Konfigurationshandbuch (49 seiten), Freigabemitteilung (48 seiten), Freigabemitteilung (44 seiten), Freigabemitteilung (22 seiten), Freigabemitteilung (3 seiten), Freigabemitteilung (40 seiten), Anmerkungen zur Veröffentlichung (10 seiten), Handbuch (16 seiten)

Installing the Switch in a Cabinet with Insufficient Front Clearance

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Installing Front Rack-Mount Brackets for Cabinets with Less Than 26

Inches of Rail Spacings

The front rack-mount brackets for the Cisco MDS 9100 Series switches must be installed onto the switch

prior to installing the switch into the cabinet. To install brackets for cabinets with front-mounting rail to

rear-mounting rail spacings less than 26 inches that need to be mounted backwards to maintain adequate

fiber-optic clearances, follow these steps:

Install the front-rack mount brackets for cabinets with rail-to-rail spacings less than 26 inches as follows:

Step 1

The front rack-mount bracket does not align with all three holes in the Cisco MDS 9100 Series switch

Note

in this configuration. The two screws are adequate to hold the weight of the Cisco MDS 9100 Series

switch.

Install the C brackets as follows:

Step 2

Two C brackets are shipped preinstalled on the switch, using three M3 screws per bracket. This

Note

installation step is only necessary if the C brackets were removed.

Figure 2-9

Cisco MDS 9100 Series Hardware Installation Guide

2-14

Position one of the front rack-mount brackets against the side of the switch and align the screw holes

as shown in

Figure

2-9. Then attach the bracket to the switch with two of the three M4 screws

originally provided with the bracket.

Repeat with the other front rack-mount bracket on the other side of the switch.

Position one of the C brackets against the side of the switch and align the screw holes as shown in

Figure

2-9. Then attach the bracket to the switch with the three M3 screws originally provided with

the bracket.

Repeat with the other C bracket on the other side of the switch.

Front Rack-Mount Brackets (Rotated) and C Brackets Installed on the Cisco MDS 9100 Series

Front rack-mount bracket

Chapter 2

C bracket

Installing the Cisco MDS 9100 Series

OL-21514-01