Cisco BTS 10200 Benutzerhandbuch - Seite 20

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schalter Cisco BTS 10200 herunter. Cisco BTS 10200 35 Seiten. Softswitch

Enable IRDP

Enable IRDP on Adjacent Cisco Routers

If you are enabling IRDP on Cisco routers adjacent to the Cisco BTS 10200 Softswitch, follow these

steps. If you have any questions about setup of these routers, contact your system administrator. If you

need additional assistance, contact Cisco TAC.

Verify that you have the network information data sheet (NIDS) applicable to this

Step 1

Cisco BTS 10200 Softswitch. If necessary, contact your network administrator to verify that you have

the correct NIDS.

Step 2

On default gateway interfaces for Network2 and Network3 (as defined in the NIDS) enable IRDP using

the following commands:

Validate the configuration by performing the following command on both CA/FS hosts and both EMS

Step 3

hosts:

Step 4

View the display and verify that each default route was populated dynamically by IRDP.

Follow these steps to verify that IRDP is functioning properly on the network:

Side A CA

Perform

Step 1

Display the IRDP daemon status by entering the following command:

Step 2

View the display and verify that each default route was populated dynamically by IRDP. The display

Step 3

should include the following information: /usr/sbin/in.rdisc -s -f. (This indicates that IRDP is running

properly.)

C I S C O C O N F I D E N T I A L

config t

interface <Fast Ethernet interface number (see NIDS)>

ip irdp

ip irdp maxadvertinterval 4

ip irdp minadvertinterval 3

ip irdp holdtime 10

#netstat -rn

Step 1

through

Step 11

ps -ef|grep in.rdisc

on the side A CA.

OL-2906-01