Cisco BTS 10200 Benutzerhandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schalter Cisco BTS 10200 herunter. Cisco BTS 10200 35 Seiten. Softswitch
Seite drucken
Connect CCPUnet Cables and Terminating Resistors
Note
Note
Refer to
Step 1
Ethernet Switch A and which is Ethernet Switch B.
Connect the "net CCN" end of a CONSOLE cable to port SER 1 on the Alarm Panel, and the "switch"
Step 2
end to the CONSOLE port on the rear panel of Ethernet switch (Hub) A.
Step 3
Connect the "net CCN" end of a CONSOLE cable to port SER 2 on the Alarm Panel, and the "switch"
end to the CONSOLE port on the rear panel of Ethernet switch (Hub) B.
The rear view of the alarm panel is shown in
Figure 5
Rear View of Alarm Panel
CCPUNet HUB A
1
2
3
4
5
6
1
2
3
4
5
6
CCPUNet HUB B
Connect CCPUnet Cables and Terminating Resistors
Follow these steps to connect the intershelf signaling (CCPUnet) cables and terminating resistors:
Obtain the eight CCPUnet cables (four for CCPU A and four for CCPU B).
Step 1
Connect the CCPUnet cables between the machines as listed in
Step 2
connect cables labeled CCPU A to the CCPU A ports, and cables labeled CCPU B to the CCPU B
ports.
Refer to
Note
Connect the two terminating resistors (part # CCPU 012 02150-02602 REV 00) to the Alarm Panel
Step 3
(Figure
CCPUNet HUB B port 5.
6
C I S C O C O N F I D E N T I A L
These two CONSOLE cables are specially designed for the CONSOLE connections. Make sure
that you are using the correct cables.
One end of the CONSOLE cable is labeled "switch" and the other is labeled "net CCN". The
"switch" end must connect to the Hub and the "net CCN" end must connect to the Alarm Panel.
Figure 1 on page 2
to identify which Cisco 2924M Ethernet Switch (Hub) is designated
LINE
SER 1
SER 3
SER 5
SER 7
SER 9
7
8
7
8
REM
SER 2
SER 4
SER 6
SER 8
SER 10
Figure 3
through
Figure 5
5) as follows: Connect one resistor to CCPUNet HUB A port 5, and the other resistor to
Figure
5. (The drawing is not to scale.)
SER 11
CONS
eth1
I/O CABLE A
I/O CABLE B
SER 12
COM1
eth0
to locate the CCPU ports on the rear panels.
-48V A
-48V B
AC IN
100-240 V-
50-60 HZ 40W
Table 1 on page
23. Make sure that you
OL-2906-01