Cisco C-series Nexus 5010 Hardware-Installationshandbuch - Seite 9
Blättern Sie online oder laden Sie pdf Hardware-Installationshandbuch für Schalter Cisco C-series Nexus 5010 herunter. Cisco C-series Nexus 5010 19 Seiten. Replacing an i/o module nexus 5000 series
Auch für Cisco C-series Nexus 5010: Spezifikationen (3 seiten), Datenblatt (23 seiten), Freigabemitteilung (26 seiten), Freigabemitteilung (3 seiten), Handbuch (11 seiten)
Seite drucken
Chapter 4
Replacing Components
This section includes the following topics:
•
•
•
You can replace a faulty power supply while the system is operating if the other power supply is
Note
functioning.
Removing a Power Supply
If you are using a Cisco Nexus 5500 Platform switch or a Cisco Nexus 5000 Platform switch with one
Caution
power supply, removing the power supply causes the switch to shut down. If you are using two power
supplies and you remove one of them, the switch can continue to operate.
To remove an AC or DC power supply, follow these steps:
Ensure that the system (earth) ground connection has been made. For ground connection instructions,
Step 1
see the
Remove the AC power cord or DC wiring connector.
Step 2
Grasp the power supply handle with your left hand.
Step 3
Push against the release latch with your left thumb, and slide the power supply part way out of the
Step 4
chassis. To remove a power supply from a Cisco Nexus 5500 Platform chassis, see
Figure
power supply from the Cisco Nexus 5010 switch, see
Figure 4-8
Removing a Power Supply, page 4-9
Installing a Power Supply, page 4-11
Wiring a DC Power Connector, page 4-12
"Grounding the Switch" section on page
4-9. To remove a power supply from the Cisco Nexus 5020 switch, see
Removing the Power Supply from a Cisco Nexus 5596 Switch
Replacing or Installing Power Supplies
2-17.
Figure
4-11.
Cisco Nexus 5000 Series Hardware Installation Guide
Figure 4-8
and
Figure
4-10. To remove a
4-9